Led Clamp; Recharge The Booster Using The Ac 230V Or 110V; Dc 12V Charger; Recharge Via Cigarette Lighter Cable Dc/Dc 12V - SOS 861002 Modo De Empleo

2.4. LED Clamp

The blue clamp is provided with a LED to avoid wrong connections in the darkness.
To light the LED, push simply on the red push-button.
This LED is supplied by 3 LR44 batteries placed in the handle of the clamp (on the
push-button's size).
2.5. Recharge the Booster using the
charger
NEVER wait until the Booster is completely discharged before recharging.
An electronic full automatic charger AC 230V or 110V/DC 12V is provided with the
Booster. Connect the charger to the sector AC 230V or 110V, then connect the
charger to the Booster via the cigarette lighter plug of the Booster. The Booster
can be left permanently connected to the automatic charger, to maintain correct
charge level.
If the light of the charger is:
Orange: your Booster is charging.
Green: your Booster is charged but it is recommended to leave it continuous
on the sector to maintain the battery in perfect condition.
Red: the charging circuit is faulty. Warning: your Booster is not charging,
contact immediately your reseller.

2.6. Recharge via cigarette lighter cable DC/DC 12V

The Booster can be recharged whilst connected to the 12V cigarette lighter socket,
(with the vehicle engine running). It is essential that the vehicle's alternator is
operating correctly. The tension at the cigarette lighter socket must be 14 to 14,4
volt, engine running.
Note: the Booster can remain connected permanently on the cigarette lighter
socket between uses. However it is recommended to disconnect the Booster, if the
vehicle is not in use for several days or to place a one-way diode on the charging
circuit.
AC 230V or 110V/DC 12V
EN
47