Electrical Safety - Black and Decker DVA325J Manual Del Usuario

ENGLISH
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code.
Read all of this manual carefully before
using the appliance
DVA325J Only use with charger
S003AQ-15 / SSC-150015
S003AQ-15 / SSC-150015
DVA325B Only use with charger
S010Q 14 / SSC140040 S010Q 14 / SSC140040
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust chamber release button
3. Dust chamber
4. Flip down brush
5. Wall bracket
6. Jack plug charger (DVA325J only)
6a. Charging base (DVA325B only)
7. Hanging attatchment
6
(Original instructions)
Use
Switching on and off (Fig. A)
Push the On/off power switch (1) to the forward position to
u
turn on the unit.
Returning the On/off power (1) switch will turn the unit off.
u
Flip down brush (Fig. B)
Flip the brush attachment (4) into position as shown in
u
figure B
Using the pull out crevice tool (Fig. C)
Extend the crevice tool (8) as shown in figure C, until it
u
clicks in place.
Note: The flip down brush (4) can only be utilised when the
crevice tool is in the retracted position.
Fitting the wall bracket (Fig. D)
Fit the wall bracket (5) to a suitable wall (preferably near a
u
power outlet) using the screws provided.
The unit can then be stored, when not in use, or during the
u
charging procedure, utilising the hanging attachment (7).
Charging with jack plug (Fig. E, F)
Place the charger (6) into the charging port (9) on the
u
handle of the unit as shown in figure E.
Place the charging plug into a power outlet and switch on
u
as shown in figure . The charger LED will light.
Charging with charging base (Fig. F1)
Place the unit on the charge base (6a) as shown in figure
u
F1.
Place the charging plug into a power outlet and switch as
u
shown in figure F1. The charger LED will light.
Cleaning the filters (Fig. G, H, I, J, K)
Press the dust chamber release button (2) as shown in
u
figure G
Seperate the dust chamber (3) from the motor unit as
u
shown in figure .
You can use the easy empty feature as shown in figure I
u
Lift the filter (8) out of the dust chamber (3) using the tab
u
(10) provided.
Empty the dust bowl (3) by lightly shaking over a suitable
u
container as shown in figure K
Rinse out the dust-bowl with warm soapy water.
u
Wash the filters with warm soapy water as shown in figur
u
L.
Allow the filters to dry naturall , using heat may cause the
u
filters to distort
Refit the filter (8) into dust chamber (3). Make sure th
u
filter tabs ( 1) face forward. Never place the filters into