Installation And Fitting - Fagor 2LF 013 IX Manual De Instrucciones

DISHWASHWER
1
CONNECTION TO THE PLUMBING
The water connection pipe is located on the back of the dishwasher:
Connect the pipe to the
a
water inlet, tighten the
connection nut and
make sure it is securely
connected to the
appliance.
b The hose must run
between the wall and
the bottom space at
the back of the
dishwasher (b1) so
that it is not squashed
or overstretched.
There should be a fixed
water outlet drain at a
distance of between 25 and
100 cm from the floor. Make
sure that the outlet pipe is
not too rigid, bent or
squashed.
I M P O R T A N T
It is very important for the bend pipe of the outlet hose is located securely in water outlet
so that it cannot disconnet. The operating water pressure (minimum and maximum) must
be between 0,5-10 bar (0,05-1 MPa).

INSTALLATION AND FITTING

a
b1
max.
100 cm
min.
25 cm
b2
If your dishwasher has a hot
water inlet, connect the pipe
to the hot water tap. In this
case, the maximum
temperature must not
exceed 60ºC. Bear in mind
that this type of water
supply may affect the
washing and drying
capacity of the appliance.
55