Installing And Removing The Battery Pack - DeWalt DCST920 Manual De Instrucciones

might be bent outwardly into the path of the appliance, such as barbs
at the base of a chain link fence.

Installing and Removing the Battery Pack

(Fig. 7, 8)
WARNING:
Before removing or installing battery, make
certain the lock-off lever is not engaged to prevent trigger actuation.
To install battery pack: Insert battery pack (L) into battery housing
(K) as shown in Figure 7 until fully seated and an audible click is heard.
FIG. 7
K
L
Make sure battery pack is fully seated and fully latched into position.
To remove battery pack: Depress the battery release button (M) on
the battery and pull battery pack out of appliance as shown in Figure 8.
Fuel Gauge Battery Packs (Fig. 9)
Some D WALT battery packs include
e
a fuel gauge which consists of three
green LED lights that indicate the
level of charge remaining in the
battery pack.
To actuate the fuel gauge, press and
hold the fuel gauge button (9A). A
combination of the three green LED
lights will illuminate designating the level of charge left. When the level
FIG. 8
M
FIG. 9
9A
9
of charge in the battery is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the battery
pack. It does not indicate appliance functionality and is subject to variation
based on product components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please call
1-800-4-D WALT (1-800-433-9258) or visit our website www.dewalt.com.
e
Switching Trimmer On and Off (Fig. 2)
To turn the appliance on, squeeze the lock-off lever (B) and then the
variable speed trigger (A). To turn the appliance off, release the variable
speed trigger and the lock-off lever.
WARNING:
Never attempt to lock the trigger in the
on position.
Speed Control Switch (Fig. 2)
This string trimmer gives you the choice to operate at a more efficient
speed to extend the runtime for larger jobs, or accelerate the trimmer
speed for high-performance cutting.
To extend runtime, push the speed control switch (C) forward toward
the auxillary handle (D) into the "LO" position. This mode is best for
larger projects that require more time to complete.
To accelerate the trimmer, pull the speed control switch back toward
the battery housing (I) into the "HI" position. This mode is best to cut
through heavier growth and for applications that need higher RPM.
NOTE: When in "HI" mode, runtime will be decreased as compared to
when trimmer is in "LO" mode.
Trimming (Fig. 10, 11)
With the trimmer on, angle it and swing side to side as shown in
Figure 10.