Husqvarna WRE 125 2011 Manual Del Usuario página 72

REAR BRAKE FLUID LEVEL CHECK
Master cylinder fluid level - visible through sight glass (1)
- must be above the minimum notch on master cylinder
reservoir.
A decrease of the fluid level will let air into the system,
hence an extension of the lever stroke.
WARNING*: If the brake pedal feels
mushy when pulled, there may be air in
the brake lines or the brake may be de-
fective. Since it is dangerous to operate
the motorcycle under such conditions,
have the brake system immediately
checked by the Husqvarna Dealer.
CAUTION*: Do not spill brake fluid onto
any painted surface or light lens.
1
MIN
EN - 28
CAUTION*: Do not mix two brands of flu-
id. Completely change the brake fluid in
the brake system if you wish to switch
to another fluid brand.
CAUTION*: Brake fluid may cause irrita-
tion. Avoid contact with skin or eyes. In
case of contact, flush thoroughly with
water and call a doctor if your eyes
were exposed.
ADJUSTMENT OF THE CLUTCH CONTROL LEVER
To adjust the clutch control lever, you will need to adjust
cable tension using the adjuster on the lever.
- Remove the rubber protection (1).
- Loosen the lock ring nut (3) and turn the tensioner
(2).
There should be at least 10 mm (0.39 in.) free play
(A) before the clutch begins to disengage.
- When through with the adjustment, tighten the lock
ring nut (3) and refit the rubber protection (1).
6
5
4
1
ADJUSTMENT OF THE STARTER LEVER
- Remove the rubber protection (4).
- Loosen the check nut (5) and turn the tensioner (6).
Free play (B) must be at least 5 mm (0.2 in.).
- When through with the adjustment, tighten the check
nut (6) and refit the rubber protection (4).
B
3
2
A