Electrical Safety - DeWalt DCS373 Traducido De Las Instrucciones Originales

NOTE: Battery packs, chargers and kitboxes are not
included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 4–6)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger switch
b. Trigger switch lock-off button
c. Depth adjustment lever
d. Spindle lock button
e. Kerf indicator
f. Blade clamping screw
g. Lower guard
h. Lower guard retracting lever
i. Battery pack
j. Sight window
k. Shoe
l. Hex key
m. Battery release button
n. Main handle
o. Auxiliary handle
p. Fuel gauge button (fig. 4)
q. Inner clamp washer (fig. 5, 6)
r. Outer clamp washer (fig. 5, 6)
s. Saw spindle (fig. 5, 6)
t. Blade (fig. 5, 6)
INTENDED USE
This metal-cutting circular saw is intended for use
by professionals for cutting light gauge metals and
small metal structural shapes.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This metal-cutting circular saw is a professional
power tool. DO NOT let children come into
contact with the tool. Supervision is required when
inexperienced operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
WARNING: Do not plunge cut or
pocket cut with this saw
WINDOW (FIG. 1)
WARNING: Do not operate the
saw with a damaged or missing
sight window. If window is damaged
or missing, have the saw serviced at
an authorised service centre. If saw is
operated without the window, metal
chips could fly through the guard and
cause personal injury.
CAUTION: Do not use oil or cutting
fluids with the metal-cutting saw.
Do not use cleaning fluids to clean
window. Cleaning fluids, cutting
fluids or oils could harm the plastic in
the window, interfering with the safe
operation of the saw.
The saw is equipped with a sight window (j) on the
side of the upper guard. This window allows the
user to see a cutting line on the material to be cut.
SAW SHOE (FIG. 1)
The front of the saw shoe (k) has a kerf indicator
(e) that allows the operator to glide the saw along
cutting lines. Aligning the cutting line with the notch
on the front of the shoe and centering it using the
modified V-shaped kerf indicator allows the operator
to keep the blade in line with the cutting line. If the
cutting line is visible through the narrowest part of
the kerf indicator, the blade will pass directly over the
cutting line.
WORKLIGHT
The saw is equipped with a worklight that is
activated when the trigger switch is depressed.
The light will automatically turn off 20 seconds after
the trigger switch is released. If the trigger switch
remains depressed, the worklight will remain on.
NOTE: The worklight is for lighting the immediate
work surface and is not intended to be used as a
flashlight.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
EN GL IS H
47