Dry Ironing; Vertical Ironing; After Ironing - ARIETE ECO POWER 6233 Manual De Instrucciones

DrY IrOnIng

Insert the plug into the wall socket.
Set the temperature control knob (F) according to the type of fabric to be ironed.
Wait a few minutes for the soleplate to reach the set temperature.

verTIcAl IrOnIng

This special ironing procedure serves to remove creases from curtains, fabrics, etc. Set the ironing temperature by turning
the adjustment knob (F) past the symbol (
press the steam button.
If the temperature lamp is on, do not press the steam button more than three times in a row.
Warning!
Do not iron fabrics held by other people.

AFTer IrOnIng

Turn the temperature control knob (F) to "MIN".
Disconnect the plug from the wall socket.
Put the iron in a vertical position and let it cool down.
Empty the tank: open the water filling cover (A), turn the iron upside-down and let the water pour out (Fig. 8).
Warning!
Let the iron cool down before emptying the tank: danger of burns.
Wrap the power cord around the iron without pulling it too tight (Fig. 6). Store the iron in a vertical position (Fig. 7).
cleAnIng The APPlIAnce
Warning!
Before cleaning, always disconnect the plug from the power point and allow the iron to cool down.
Warning!
Never immerse the appliance in water or other liquids.
Warning!
Check the state of the power cable of your iron on a regular basis before using it, and if it is damaged, take it to the
service centre closest to you to have it replaced only by specialised personnel.
selF cleAn system
to prolong the life of your iron, we recommend that this procedure be carried out at regular intervals (once or twice
a month).
Fill the tank one-fourth full with water using the measuring cup (P) provided (Fig. 5).
Fill the tank up to the level marked MAX.
Set the iron on a stable surface in a vertical position on the iron stand (H). Plug it into the socket. Make sure the steam
adjustment selector is set on "0".
Position the temperature adjustment knob on "MAX".
Heat the iron until the lamp (E) turns off a second time.
Position the temperature adjustment knob on "MIN".
Unplug the iron and keep the iron in a horizontal position on a sink.
Press the SELF CLEAN button (M) and keep the iron in a horizontal position. Steam and boiling water will come out of the
holes of the soleplate. They will remove the lime deposits and impurities that have accumulated inside the soleplate.
Gently move the iron back and forth until the tank is completely emptied.
Put the steam adjustment selector back on minimum "0" at the end of the self-cleaning procedure.
Put the iron in a vertical position on its stand and wait for the soleplate to cool down completely.
Make sure that the soleplate is completely dry before storing the iron.
Before using the iron again, try it on an old piece of cloth to make sure that the soleplate and tank are clean and to
allow residual water to vaporize.
the Warranty does not cover damage caused By cLogging due to Lime
Move the steam adjusting knob (B) onto "0".
•••
). Put the curtain or fabric in the position you want to iron it vertically and
13