Technical Data - Urrea BAL24 Manual De Usuario

Computer board fault. Change the computer
board.
DISPLAY IS NORMAL BUT THE START
BUTTON AND INPUT PUSH BUTTON NOT
WORKING
Contact switch not good. Open the housing of
the machine and plug in and tight the contact
switch plug.
Machine breakdown. Start the machine again.
DISPLAY IS NORMAL BUT NOT BRAKING AF-
TER START
The cable between the power board and com-
puter loose. Plug in and tight the cable bet-
ween the computer board and power board.
Power board fault. Change the power board.
Computer board fault. Change the computer
board.
BALANCE IS NOT ACCURATE & DIFFICULT
TO REACH "00"
Sensor lead connect or contact no good. Con-
nect again.
Memory value lost. Correct the memory value
according to the manual.
EACH SPIN, THE CHANGE OF THE VALUE
WILL NOT EXCEED 5g
There are foreign body on the rim or the assem-
ble surface in the rim center deformation. Chan-
ge the wheel.
Sensor damp or quick nut not tightly clamped.
Oven, recalibrate the sensor.
The external power voltage or the air pressure
not enough. The flange dick not locked. Fix the
anchor bolt.
EACH SPIN, THE RANGE OF THE CHANGE OF
VALUE WILL BE 20—90g
There are foreign bodies on the wheel or the
unbalance of the wheel value too big. Change
the wheel.
Sensor damage. Check the sensor and wiring.
External power source voltage too low. Check
power source and assemble stabilizer.
BALANCE IS NOT ACCURATE & DIFFICULT
TO REACH "00"
Sensor damp or damage. Calibrate again,oven
and then self-calibration or change.
Program chore. Self-calibration again.
E N G L I S H •
WHEN SECOND MOUNT & DEMOUNT, THE
ERROR WILL EXCEED 10g
Wheel internal hole irregular. Change the
wheel.
Flange disk assemble not properly. Check the
assemble surface and try again.

TECHNICAL DATA

VOLTAGE-FREQUENCY
PHASE
BALANCING TIME
ACCURACY
MAXIMUM WHEEL DIA.
RIM DIAMETER
TIRE WITDH
MAX. TIRE WEIGHT
U se r's m a nua l
120 V ~ 60 Hz
1~
10 s
1 g
35" (89 cm)
10" - 24"
1 1/2" - 20"
65 kg (163 lb)
27