Urrea BAL24 Manual De Usuario página 22

ter a few seconds, the machine automatically
stops. The machine can also start by lowering
down the protective hood which can be set by
the program.
DISPLAY UNBALANCE VALUE
When the spin ends, the display will display
the inner and outer unbalance value of the
rim. Use your hand to pull the wheel. When
all the positioning lamps light inside and out-
side light, the weight adding position will be
indicated.
Rotate the wheel, when the left side position-
ing lamp all light, at this moment, the highest
position is the inner unbalance position and
when the right side positioning lamp all light,
at this moment, the highest position is the out-
er unbalance position.
Add the corresponding weight at the unbal-
ance point and start test again until the bal-
ance of the tire.
CAUTION
1. When start the machine, use hand to pull
the wheel to help it start rotation, especially to
the relative bigger tire, to prolong the working
life of the motor.
2. Check if there are any mistakes on the di-
mension.
3. Check if the balance methods meet the con-
figuration of the rim and select the balancer
most easily to balance.
4. Check if the quick lock nut tight or not.
5. When the balance ends, remove the tire. Pay
attention to handle it with gentle and avoid
knocking the main shaft.
6. When clipping the weight. Use the hammer
to clip the weight on the rim without too much
force. Do not knock the main shaft hardly to
avoid damaging the sensor. The position to
add the Weight should be free from the grease
and should be dry.
RESIDUAL UNBALANCE VALUE DISPLAY
The minimum value of the standard weight is
5g so if the weight you use is less than 5 g, the
wheel balancer will not display the value and
only displays the state of "00". When you need
to display the residual unbalance value, you
should press the BALANCE key and the display
will immediately display the inside or outside
22
unbalance value of less than 5g. The maximum
residual unbalance value is 4 g.
BALANCE MODE SELECT
Select the balance mode according to the
weight adding position and the balance mode.
Press the corresponding key to select the bal-
ance mode. When you switch on the machine
the machine will automatic enter into the dy-
namic balance mode and no need to select.
DYNAMIC: Clip the weight on
both side of rim (dynamic ba-
lance test once start).
STATIC: use this mode when there can not add
weight on both sides
MOT: Optional for balancing the motorcycle
When balance the motorcycle, you need the
special motorcycle adaptor accessory and with
the assistance of the extension scale to measu-
re Di, Br and Di. Input the measure value into
the Di, Br and Di display window. The input
method is similar to the parameter input of
the car.
ALU1: To balance the light alu-
minum alloy rim. Adopt clip
the weight on the shoulders
of the rim
3/4" 3/4"
1/2"
ALU2
ALU2: For ALU rim, hidden
weight inside.
1/2"
3/4"
1/2"
1 1/4"
Di1=Di+3/4"
Di2=Di+Br-3/4"
D1=D-1"
D2=D-1"
Di1=Di+3/4"
Di2= (del punto 0
al exterior del disco
de reborde)-1/2"
D1=D-1"
D2=D-2 1/2"