Urrea BAL24 Manual De Usuario página 21

tires. You can select the methods according to
the different conditions.
SMALL CAR WHEEL POSITIVE POSITION
Positive positioning is the normal method. It is
featured with simple and quick operation. It is
mainly suitable to the common steel rim and
aluminum alloy rim with small deformation.
When the deformation of the outside of the
wheel, adopt this method to positioning to
grantee the accurate positioning of the steel
rim inner hole and main shaft. It is suitable to
the steel rim, especially the thick ALU.
FLANGE DISK POSITIONING (OPTIONAL)
Suitable to the big tire assemble.
NOTE: The choice on the cone should be adapt-
ed to the rim center hole and pay attention to
its direction. Or it will cause the inaccurate
measurement.
INPUT VALUE
Main shaft wheel -->
direction of the rim
installation surface is
inside --> cone quick
nut.
Main shaft wheel -->
lower spring --> suit-
able cone --> wheel
--> bowl --> quick nut.
Main shaft --> flange
disk (fixed on the
main shaft) --> wheel
--> cone --> quick nut.
E N G L I S H •
Input DIS (Distance)
Pull the scale to the inner position to add the
weight and press the key (Dis -/+) to input the
DIS value into the display. At this moment, the
display will display "DIS":"XXX". And the de-
fault system is mm.
The standard scale handle and directly contact
with the external flange of the 21" rim. When
the size exceeds this Dis value, you should op-
tionally purchase the extended scale handle
supplied by the supplier.
Input Br (RIM Breadth) Value
Use the Br measurement caliper to measure
the Br of the rim, press the (Br -/+) key to input
the Br value into the display. At this moment,
the display will display "Br":"XXX".
Input the DiA(Diameter)Tire Diameter Value
After confirming the rim diameter, press the
key (DIA -/+) to input the rim diameter into the
display. At this moment, the display will display
"D":"XXX".
UNIT CONVERSION
1. The unit conversion of the Br of the rim from
inch to mm:
Normally, the display of Br should be in inch.
When you need the unit of the display to be
mm, you can use the "C" key to realize the unit
conversion from inch to mm.
2. The unit conversion of the DIA of the rim
from inch to mm:
Normally, the display of D should be in inch.
When you need the unit of the display to be
mm, you can use the "C" key to realize the unit
conversion from inch to mm.
After unit conversion, the unit of the display
values of rim Br and D are , but when you
switch off and then on the wheel balancer, the
unit will be still inch.
3. The unit conversion from gram to ounce:
Normally, the unit of the unbalance value is
gram (g). If you want to make the ounce(Oz)
to be the unit, you can execute the g/Oz con-
version. The unit of the displayed unbalance
value is gram (g). The way to realize the unit
conversion from gram to ounce is to press 6.4.5
IMPORTANT: When press the start key
"START" the wheel balancer starts to run. Af-
U se r's m a nua l
21