Changing The Printer Paper - MasterCool ULTIMA ID PRO 2 Manual Del Usuario

3.4

Changing the Printer Paper

All Ultima ID Pro™ Refrigerant Analyzer is equipped with on-board printer that uses an
inexpensive thermal paper for printing. The paper roll should be changed when a red stripe
appears on the left side of the printout.
To change the paper roll, press the 'SET' button shortly after powering the analyzer on or
any time it appears. The screen will display several options as shown in (Figure 29). Press
the 'FEED' button to advance to the screen shown in (Figure 30).
TO FEED IN A
NEW PAPER ROLL
PRESS FEED
PRESS SET TO
ADJ LCD CONTRAST
BACK
Open the printer door and remove the old roll by tearing the paper as it enters the printer
then pressing the 'FEED' button shown in (Figure 30) until the old roll exits the printer
completely. Insert the new paper roll from the underside as shown below:
Press the 'FEED' button shown in (Figure 30) to automatically advance the paper through
the printer. Allow at least 3 in (7cm) of paper to exit the top of the printer. Press the 'DONE'
button to stop the printer from advancing the paper. This will take you back to (Figure 29).
Slide the paper through the slot in the printer door and close the door.
Manual Part Number:
5-06-7000-70-2
FEED SET
Figure 29
Manual File:
MN-A-0289 Rev. E
TO LOAD PAPER
1.
PRESS FEED
2. INSERT PAPER
3. PRESS DONE
TO EXIT
FEED
Figure 30
DONE
Page 3-25