Replacing Components; Reminders For Replacing Components; Gas Fry-Top With Tap; Gas Fry-Top With Valve - AFG 700 Serie Instrucciones Para Instakkacion, Uso Y Manteniniento

20 REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS.

• Disconnect the appliance electric supply, if present, before
carrying out any operation.
• After replacing a gas system component, check for gas leaks
at connection points.
• After replacing an electrical system component, check it is
correctly wired.
20.1

GAS FRY-TOP WITH TAP

Replacing the gas tap
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the burner, the pilot burner , the thermocouple,
the piezoelectric ignition and the igniter.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
20.2

GAS FRY-TOP WITH VALVE

Replacing the gas valve and safety thermostat.
• Remove the control panel.
• Remove the bulb from its seat on the bottom of the hotplate.
• Remove and replace the component.
• Insert the bulb properly in its seat on the bottom of the hotpla-
te.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the burner, the pilot burner , the thermocouple,
the piezoelectric ignition and the igniter.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
20.3

ELECTRIC FRY-TOP

Replacing the heating element and the indicator light
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the working thermostat and safety thermostat
• Remove the control panel.
• Remove the bulb from its seat on the bottom of the hotplate.
• Remove and replace the component.
• Insert the bulb properly in its seat on the bottom of the hotpla-
te.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
20.4

ELECTRIC OVEN

Replacing the knob and indicator light
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the working thermostat and safety thermostat
• Remove the control panel.
• Remove the bulb from its seat on the side of the oven.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the heating element
• Remove the oven floor (only for lower heating elements) or
the higher protection (only for higher heating elements).
• Undo the screw securing the element to the oven and pull the
element out by approx. 5 cm.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.

21 CLEANING THE INTERIOR

• Check the condition of the inside of the appliance.
• Remove any built-up dirt.
• Check and clean the fumes exhaust system.

22 MAIN COMPONENTS

22.1 GAS FRY-TOP WITH TAP
• Gas tap
• Main burner
• Pilot burner
• Thermocouple
• Igniter
• Piezoelectric ignition
22.2 GAS FRY-TOP WITH VALVE
• Gas valve
• Main burner
• Pilot burner
• Thermocouple
• Igniter
• Piezoelectric ignition
• Safety thermostat
22.3 ELECTRIC FRY-TOP
• Working thermostat
• Safety thermostat
• Heating element
• Indicator light
22.4 ELECTRIC OVEN
• Control knob
• Working thermostat
• Safety thermostat
• Heating element
• Indicator light
37