Regalo 2020 Manual Del Usuario página 4

STEP 3
Tighten the straps to bring the bed rail into
its proper position. To tighten the straps, first
release the strap locks on the under side of
the left and right under bars. Pull the straps
towards you until all the excess slack has
been pulled out from under the mattress.
Operating the Swing Down Feature
STEP 1
With the bed rail side in the 'up' position, release the locking tabs
on each swing lock and arm assembly by pushing them up. This will
allow the upper part of the bed rail to move freely.
NOTE: Be sure to continue to hold the upper part of the bed rail so
that it does not drop down on its own.
STEP 4
If the strap does not pull through smoothly, the strap
may be twisted under the mattress. Correct this before
continuing with the installation. Once you have taken
the slack out of the straps, give one final pull on the
strap end, hold it, and push down on the locking
buckle to secure the strap tension. Use the same
procedure for each side to properly secure the bed rail.
NOTE: When using this bed rail on a foam mattress
with little or no internal structure, make sure not to
over tighten the mounting straps. If over-tightened,
the mattress will likely fold or buckle in the middle
and this will cause the bed rail to not provide your
child with the highest level of safety. Make slight
adjustments to find the best level of tightness on
your mattress. The bed rail must be tight but should
not buckle or fold.
With both locking tabs turned to the 'open' position, hold the upper part of the
bed rail firmly and swing it down. The bed rail should now be in the 'down'
position. To return the bed rail to the 'up' position, reverse STEPS 1 – 2.
NOTE: Make sure that the bed rail is in the 'up' position and the locking tabs
are securely closed before leaving a child alone in the bed.
STEP 5
LOCKING
BUCKLE
With your bed rail in the 'up' position push down
on the locking tabs to secure your bed rail in
place.
NOTE: After locking both buckles, check to
make sure that the mesh wall of the bed rail is
firmly up against the side of the mattress. There
should be NO GAPS. If the mesh wall is not
firmly against the side of the mattress, check to
make sure the locking buckle is functioning
properly and that the strap is not twisted
beneath the mattress. Once this has been
checked and corrected if needed, unlock the
buckle, pull on the end of the strap tightly and
lock the buckle again. Store the excess
anchoring strap material by tucking it under the
mattress. Do not cut excess strap, may cause
strap to fray.
STEP 2
LOCKING
TAB