Regalo 2020 Manual Del Usuario página 3

STEP 3
To install the mesh wall (A) on the bed rail, slide it
over the frame until it reaches the other end, zip it
shut, then attach the velcro strap over the zipper to
complete the installation. Mesh wall must go over
entire bed rail frame.
NOTE: If the zipper does not close securely, make the necessary adjustments to ensure proper
closure. DO NOT use the bed rail without securely zipping the mesh wall properly.
Installing Your Bed Rail
STEP 1
Start by placing the bed rail on the side of the bed
you have chosen for installation. The left and
right swing lock and strap assemblies should be
placed on top of the box spring that will support
the mattress. The 'T' shaped anchors and straps
should be extended opposite the bed rail and
mounted to the outer edge of the box spring or
mattress support structure.
STEP 4
With the wall of the bed rail completely
assembled, you will now connect the hinge
assemblies (F, G).
STEP 2
Once the bed rail is properly placed, check to make
sure the left and right swing lock and strap
assemblies are parallel to one another. Then, place
the mattress on top of the assembly.
NOTE: In order for the bed rail mesh wall to be
firmly held against the side of the mattress
you MUST properly tighten the anchoring
straps. Please follow the next STEPS 3 – 4
carefully.
STEP 5
SPRING BUTTON
Insert one side of the wall frame with locating pin
into the hinge assembly labeled "B". Press in the
metal spring button to fully insert the tube into the
hole in the plastic hinge. The spring button should
line up with the access hole in the plastic sleeve
on the hinge. The spring button will rebound and
lock the tube in place. Repeat on opposite hinge
assembly "A".
NOTE: You may need to release
the strap locking buckles located
on the under side of the plastic
hinges. Ensure that the large end
of the anchor is pointing up. The
anchoring straps should not be
twisted. If twisted, the anchoring
straps will not tighten properly.