Idiomas disponibles
Idiomas disponibles
10. Route the overlay harness (1) along the existing wiring
harness behind the cowl panel on the driver side.
11. Secure the overlay harness to the existing wiring har
ness with tie straps.
12. Raise and support the vehicle.
13. Remove the front screws from the driver side inner
fender (2).
14. Remove the push pins (1) and remove the driver side
inner fender (2) from the vehicle.
15. Remove the grommet (1) from the hole in the body in
the corner of the front driver inner fender.
16. Using a small flat bladed screwdriver or equivalent,
carefully position the tool into the opening
between the cable and the grommet .
17. Feed the overlay harness (2) through the grommet
opening and route along the existing harness.
18. Secure the overlay harness to the existing harness
with tie straps.
Oct 26, 2011
5
K6861339
