Idiomas disponibles
Idiomas disponibles
10
35. Position the rear fog lamp relay (1) near the TIPM and
secure with a tie strap (2).
36. Reinstall the TIPM to the bracket. Make sure all four
retaining tabs are seated properly.
37. Route the overlay harness along the edge of the inte
rior, below the door sills, B pillar trim, and rear quarter
trim.
38. Raise and support the vehicle.
39. Remove the grommet (1) from the hole in the body in
the driver rear corner of the vehicle.
40. Using a small flat bladed screwdriver or equivalent,
carefully position the tool into the opening
between the cable and the grommet .
41. Feed the overlay harness (2) through the grommet
opening and route along the existing harness.
42. Secure the overlay harness to the existing harness
with tie straps.
43. After routing the overlay harness, seat the grommet
(1) back into the body hole from which it was removed.
Oct 26, 2011
K6861339
