Name Of Parts; Units Installation - Hitachi RCI-FSN3E Manual De Instalación Y Funcionamiento

2 Name of parts

2 NAME Of PARTS
  
RCI

3 UNITS INSTALLATION

D A N G E R
• Check to ensure that the accessories are packed with the indoor unit.
• Do not install the indoor units outdoors. If installed outdoors, an
electric hazard or electric leakage will occur.
• Consider the air distribution from each indoor unit to the space of
the room, and select a suitable location so that uniform air tem-
perature in the room can be obtained. It is recommended that the
indoor units be installed 2.3 to 3 meters from the floor level. If the
unit is installed higher than 3 meters, it is also recommended that
a fan be utilised to obtain uniform air temperature in the room.
• Avoid obstacles which may hamper the air intake or the air dis-
charge flow.
• Pay attention to the following points when the indoor units are
installed in a hospital or other places where there are electronic
waves from medical equipment, etc.
I-Beam
Suspension Bolts
(W3/8 or m10)
• Do not put any foreign material into the indoor unit and check to ensure that none exist in the indoor unit before the installation and test
running. Otherwise a fire or failure, etc., may occur.
For Concrete Slab
150~160mm
Concrete
Steel
Anchor Bolt
3 PmmL0231A rev. 0 - 02/2011
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
• Do not install the indoor units where electromagnetic wave is directly
radiated to the electrical box, remote control cable or remote control
switch.
• Prepare a steel box and install the remote control switch in it. Pre-
pare a steel conduit tube and wire the remote control cable in it.
Then connect the ground wire with the box and tube.
• Install a noise filter when the power supply emits harmful noises..
• This unit is exclusive non electrical heater type indoor unit. It is
prohibited to install a electrical heater in the field.
• Mount suspension bolts using M10 (W3/8) as size, as shown below:
Wooden Bar
(60 mm to 90 mm
Nuts
Square)
Wooden Beam
Sling Bolt
(W3/8 or m10)
Part Name
Fan
Fan motor
Heat Exchanger
Distributor
Expansion Valve
Electric Control Box
Gas refrigerant Connection
Liquid refrigerant Connection
Drain Pipe Connection
motor for Drain Discharge mechanism
Float Switch
Drain Pan
Panel P-N23WA
Air Filter
Air Outlet
Air Inlet
Strainer
Air Inlet Grille
Cover for Corner Pocket
Square washers