Name Of Parts; Units Installation - Hitachi RPI-16.0FSN3PE-f Manual De Instalación Y Funcionamiento

NAME OF PARTS

2 NAME OF PARTS

RPI-(16.0/20.0)FSN3PE(-f)

3 UNITS INSTALLATION

!
D A N G E R
• Check to ensure that the accessories are packed with the
indoor unit.
• Do not install the indoor units outdoors. If installed
outdoors, an electric hazard or electric leakage will occur.
• Consider the air distribution from each indoor unit to the
space of the room, and select a suitable location so that
uniform air temperature in the room can be obtained.
• Avoid obstacles which may hamper the air intake or the
air discharge flow.
• Do not install the indoor units where electromagnetic
wave is directly radiated to the electrical box, remote con-
trol cable or remote control switch.
• Prepare a steel box and install the remote control switch
in it. Prepare a steel conduit tube and wire the remote
control cable in it. Then connect the ground wire with the
box and tube.
• Install a noise filter when the power supply emits harmful
noises.
• This unit is exclusive non electrical heater type indoor
unit. It is prohibited to install a electrical heater in the
field.
• Do not put any foreign material into the indoor unit and
check to ensure that none exist in the indoor unit before
the installation and test running. Otherwise a fire or failu-
re, etc., may occur.
3 PMML0323A rev.5 - 05/2016
No.
1
Fan
2 Fan Motor
3 Heat Exchanger
4 Strainer
5 Wiring holes
6 Expansion Valve
7 Electrical Box
8 Refrigerant Gas Pipe
9 Refrigerant Liquid Pipe
10 Drain Pipe
11 Air Filter
12 Hook
13 Air Inlet
14 Air Outlet
15
Capacitor
16
Fan service cover
!
C A U T I O N
• Do not install the indoor units in a flammable environment to avoid a
fire or an explosion.
• Check to ensure that the ceiling slab is strong enough. If not strong
enough, the indoor unit may fall down on you.
• Do not install the indoor units, outdoor unit, remote control switch and
cable within approximately 3 meters of strong electromagnetic wave
radiators such as medical equipment.
• Do not install the indoor units in a machinery shop or kitchen where
vapor from oil or mist flows to the indoor units. The oil will deposit on
the heat exchanger, thereby reducing the indoor unit performance,
and may deform. In the worst case, the oil damages the plastic parts
of the indoor unit.
• To avoid any corrosive action to the heat exchangers, do not install
the indoor units in an acid or alkaline environment.
• When lifting or moving the indoor unit, use appropriate slings to avoid
damage and be careful not to damage the insulation material on units
surface.
Part Name