Packing List - Ryobi RBL42BP Manual De Utilización

Ocultar thumbs Ver también para RBL42BP:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call your
Ryobi service centre for assistance.

PACKING LIST

Backpack blower
Upper tube
Bellows tube
Lower tube
Nozzle
Locking clamps
2-cycle engine lubricant
Operator's manual
NOTE: Read and remove all hang tags and store with your
operator's manual.
WARNING
If any parts are damaged or missing, do not operate the
product until the parts are replaced. Use of the product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
ASSEMBLING AND DISASSEMBLING THE UPPER
TUBE AND BELLOWS TUBE
See Fig. 2.
1. Attach the bellows tube to the main housing outlet and
secure with a locking clamp.
2. Attach the upper tube to the bellows tube. Secure the
upper tube in place using the locker clamp.
English (Original instructions)
3. To disassemble, loosen the locking clamps using a
ASSEMBLING AND DISASSEMBLING THE LOWER
TUBES AND NOZZLE
See Fig. 2.
1. Align the raised locking tabs on the lower tube to the
2. Secure the nozzle and lower tube together by aligning
3. To disassemble, raise the locking tab with a fl at head
ADJUSTING HARNESS AND WAIST STRAPS
Make all adjustments to the harness straps before
starting the blower to avoid the possibility of injury.
To adjust harness strap assembly:
■ Blower should be in operating position before adjusting
■ There are two possible height adjustment positions
■ Slip top buckle of harness from adjustment slot and
■ Tighten (pull down on strap) or loosen (lift up on tab
■ Chest strap should be tightened or loosened until
To adjust waist strap assembly:
■ Waist strap should be tightened or loosened until
OPERATION
Petrol is extremely fl ammable and explosive. A fi re or
explosion from petrol will burn you and others.
19
hex wrench. Pull the upper tube and bellows tube from
the main housing.
slots on the upper tube. Slide together and tighten
securely by twisting.
the raised locking tab on the lower tube with the raised
slot on the nozzle.
screwdriver, rotate the tube and nozzle to unlock and
remove from the main housing outlet.
CAUTION
the harness straps. Slip arm through harness strap
and onto shoulder, then repeat for the other shoulder.
that can be used to easily adjust harness.
position to desired height location.
of strap buckle) each harness strap as needed, until
each is adjusted to a comfortable operating position.
adjusted to a comfortable operating position.
adjusted to a comfortable operating position.
WARNING
Tabla de contenido
loading

Tabla de contenido