Programme Activation - Jacuzzi sasha Uso-Mantenimiento

Ocultar thumbs Ver también para sasha:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 130
programme
activation
each programme
can last 6 or 12 hours
(the duration is
decided at the
installation stage,
using the relevant
switch; refer to the
relative manual).
Press the ON/OFF key: it will light up blue and the keys relative to the programmes and
the alarm key will simultaneously light up: the display is ready to receive instructions.
NOTE:
- This mode lasts approximately one minute, after this time, if no key has been pressed, the
system reverts to "stand-by" mode.
- The activation of any key is indicated by an acoustic signal.
- If an audio kit is installed (optional), the keys relative to the audio system , will also light up
on on the display.
Select one of the three programmes and activate it by pressing one of the indicated
keys (once pressed, the key will turn blue):
WARNING: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
- Bio sauna (the "water pitcher" key lights up and an acoustic signal sounds: check that there
is water in the steamer and re-press the "water pitcher" key; if you do not press the key, the
steamer will not be activated and the programme will be carried out in "dry run" mode.).
- Roman Sauna (the "water pitcher" key lights up and an acoustic signal sounds: check that
there is water in the steamer and re-press the "water pitcher" key; if you do not press the key, the
steamer will not be activated and the programme will be carried out in "dry run" mode.).
- Finnish sauna
Every programme can be interrupted at any time by pressing the key relative to the
programme itself.
It is also possible to switch from one programme to another, by first deactivating the
programme in progress.
The relative humidity varies greatly dependent on distribution of temperature values within
4 0
3 0
2 0
5 0
6 0
1 0
the sauna; the values indicated by the hygrometer are therefore approximate.
7 0
0
8 0
1 0
0
3 0
4 0
2 0
5 0
6 0
1 0
7 0
0
8 0
0
1 0
When using the Finnish sauna for the first few times, you may note the presence of steam
condensation on the inner sides of glass: this is caused by wood humidity (moisture in wood)
and, with use, will eventually disappear.
The temperature inside the sauna room (approximate and measured near the ceiling)
is displayed by the "thermometer" symbol on the keypad; this is divided into three sec-
tors, which, when turning on (progressively) indicate an increase in temperature. The typ-
ical temperature of the selected programme is reached when all sectors are illuminated.
Each programme has a predefined light colour (the shown symbol lights up); specifically
designed to heighten those feelings of well-being and relaxation that Sasha offers.
Refer to the Chapter "Cromodream® for more detailed information.
An hourglass is provided to help you time your session in the sauna; the time needed
for the sand to drop to the bottom of the hourglass is approx. 15 minutes.
44
Tabla de contenido
loading

Este manual también es adecuado para:

Sasha 2.0

Tabla de contenido