Kohler K-702210 Guia De Instalacion página 4

1. Determine the Installation Configuration
IMPORTANT! If your installation configuration includes a transom, use the installation packed with the
transom assembly.
Determine whether the door will pivot on the right or left side.
NOTE: The door must hinge directly off the expander jamb attached to the wall.
Make sure the door can swing freely in the chosen configuration.
Determine if this is a steam door installation. If it is a steam door, the height (distance A) must be
between 76" (193 cm) and 76-1/2" (194.3 cm). The height for non-steam door installations must be
76" (193 cm) or greater.
2. Measure and Cut the Expander Jambs and the Cover Strips
CAUTION: Risk of personal injury. Always wear safety glasses while cutting.
NOTE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
Steam Installation
Carefully measure the height (A) of the finished opening. Refer to the roughing-in sheet to confirm
that the door will fit in the finished opening.
Cut both the expander jambs and both cover strips to this measurement. For best results, use a
32-teeth per inch hacksaw blade and a miter box.
Non-Steam Installation
Cut the expander jambs and the two cover strips to 76" (193 cm) in length.
3. Measure and Cut the Header, the Header Expander, and the Threshold
CAUTION: Risk of personal injury. Always wear safety glasses while cutting.
NOTE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
1015287-2-B
B
A
A = Height
B – 1/2" (1.3 cm) = Width
4 Kohler Co.