Blower Safety Warnings - R RBV26B Manual De Utilización

■ Keep proper footing and balance. Do not overreach.
Overreaching can result in loss of balance.
■ Do not allow hands or any other part of the body or
clothing inside the feeding chamber, discharge chute,
or near any moving part.
■ Never use the product with defective guards or shields,
or without safety devices, such as debris collector, in
place.
■ Do not modify the product in any way or use parts
and accessories that are not recommended by the
manufacturer.
WARNING
Before using the product in vacuum mode, you must
assemble the upper and lower vacuum tubes together.
This is a one-time operation only. Never operate the
vacuum with only the upper vacuum tube fi tted. The risk
of personal injury is signifi cantly increased if you fail to
follow this warning.
WARNING
If the product is dropped, suffers heavy impact, or
begins to vibrate abnormally, immediately stop the
engine and inspect for damage or identify the cause of
the vibration. Any damage should be properly repaired
or replaced by an authorised service centre.
■ Do not touch the area around the silencer or engine
of the product. These parts get hot during operation.
■ Stop the engine and allow the product to cool down
before refuelling.
■ For refuelling and fuel mixing, chose an area that is
well-ventilated, and is away from ignition sources,
such as sparks or flames, and flammable materials.
■ Do not smoke when mixing fuel or filling the fuel tank.
■ Mix and store fuel in a container approved for fuel.
Keep an appropriate type of fire extinguisher nearby
for dealing with fuel fires.
■ Remember to securely refit the fuel tank cap before
starting the engine.
■ Wipe away any fuel spillage. Move 9 m away from
refuelling site before starting engine.
■ To reduce the risk of injury associated with contacting
rotating parts, always stop the engine and disconnect
the spark plug boot. Make sure all moving parts have
come to a complete stop before:
● leaving the product unattended
● clearing blockages or unclogging chute
English (Original instructions)
■ Immediately stop the engine in an event of accident

BLOWER SAFETY WARNINGS

■ Wear a face filter mask in dusty conditions to reduce
■ Slightly dampen surfaces in dusty conditions.
■ Do not use the product near open windows.
■ Use the full blower nozzle extension so that the air
■ In blower mode, use the product with the vacuum
■ Do not point the blower nozzle in the direction of
■ Never place objects inside the blower tubes.
■ Do not place the product on top of or near loose debris.
VACUUM SAFETY WARNINGS
Never operate the vacuum with only the upper vacuum
tube fitted. Failure to follow this warning increases the
risk of personal injury.
NOTE: Without the lower vacuum tube fitted, it is much
easier to reach up inside the tube towards the fan blade.
■ Do not operate the vacuum without the debris collector
■ Move the vacuum from side to side along the outer
14
● checking, cleaning, or working on the product
● inspecting the product after striking a foreign object
or breakdown. Do not operate the product again until
it has been fully checked by an authorised service
centre.
the risk of injury associated with the inhalation of dust.
stream can work close to the ground and perform
effectively.
tubes fitted, or you may choose to remove them and
close the fan guard. You must never separate the
vacuum tubes and operate with only the upper tube
fitted. These tubes are designed to be a one-time fit.
If you attempt to separate the fitted vacuum tubes, the
tubes will be damaged. This significantly increases the
potential for serious injury by contact with the rotating
fan.
people or pets.
Debris can be sucked into the intake vent, resulting in
possible damage to the product.
WARNING
bag assembly installed. Flying debris could cause
serious injury. Make sure that the debris collector bag
is in good condition and completely closed before
operating the product.
edge of the debris. To avoid clogging, do not place the
vacuum tube directly into the debris pile.