Tabla de contenido
EX3™ Stepper
TABLE 4
RECOMMENDED SEPARATION DISTANCES BETWEEN PORTABLE AND MOBILE RF COMMUNICATIONS EQUIPMENT AND THE EX
The EX3 Stepper is intended for use in an electronic environment in which radiated RF disturbances are controlled. The customer or the user of the EX3
Stepper can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and the EX3 Stepper as recommended below, according to the maximum output power of the communications equipment.
Rated maximum output power of
transmitter
(W)
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
transmitter manufacturer.
NOTE: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects
and people.
STORAGE AND DISPOSAL
WARNING
Dispose of single-use components as infectious waste. Reprocess reusable components after each use according to instructions for use.
n
NOTE:
Device should be stored to keep all components together and secure.
n
For questions or to order additional CIVCO products, please call +1 319-248-6757 or 1-800-445-6741 or visit www.CIVCO.com.
n
All product to be returned must be in its original packaging. Contact CIVCO for further instructions as needed.
n
Separation distance according to frequency of transmitter (m)
150 kHz to 80 MHz
d
= 1.2
0.12
0.37
1.2
3.8
12
11
(m)
80 MHz to 800 MHz
d
= 1.2
0.12
0.37
1.2
3.8
12
English
3
STEPPER
800 MHz to 2,5 GHz
d
= 2.3
0.23
0.73
2.3
7.3
23
Tabla de contenido
