Idiomas disponibles
Idiomas disponibles
15. T ake pre-assembled K, L and M clamp assemblies. Mount assemblies K and L
in the determined location on unit. Use plates M and large bolts N, lock
washer T and nuts R to secure K, L and M assemblies to unit. Now tighten
small bolt P so both clamp assemblies extend equal distance from frame.
NOTE: Location of lock washer T should be underneath nut R.
NOTE: If your snow blower is equipped with the electric joystick, mount
the clamps (L) and (K) to the horizontal handle bar. Be sure to mount
these on the opposite side of the chute control rod.
N
M
N
16. Place crossbar (J) against assembly K and L. Center crossbar (J) against
unit. Use two remaining M plates, large bolts N, lock washer T and nuts R
to secure crossbar. See Figure 15A.
T
L
T
R
Fig. A
K
P
M
L
Upper Vertical
Handle Bars
Lower Horizontal
Handle Bar
M
J
K and L
M
7
