Control Panel; Graphic Display; Navigation Buttons; Warning Lights - DAB EvoPlus B 120/220.32 M Instrucciones Para La Instalación Y El Mantenimiento

Regulation indicated for:
- Plants with variable flow (two-pipe heating
- Plants with constant flow (single-pipe and under-

9. CONTROL PANEL

The functions of EVOPLUS circulators can be modified by means of the control panel on
the cover of the electronic control device.
On the panel there are: a graphic display, 4 navigation keys and 3 LED warning lights
(see Figure 10).

9.1 Graphic Display

Using the graphic display it will be possible to navigate in an easy and intuitive menu
which will enable you to check and modify the system operating mode, the enabling of
the inputs and the working set-point. It will also be possible to view the system status and
the log of any alarms memorised by the system.

9.2 Navigation Buttons

4 buttons are provided for navigating in the menu: 3 buttons under the display and 1 at
the side. The buttons under the display are called active buttons and the one at the side
is called hidden button. Each page of the menu is made in such a way as to indicate the
function associated with the 3 active buttons (the ones under the display).

9.3 Warning Lights

Yellow light: System live signal.
If lit, it means that the system is live.
Never remove the cover if the yellow light is lit.
Red light: Warning of an alarm/malfunction present in the system.
If the light is blinking it is a non-blocking alarm and the pump can still be controlled. If the
light is fixed it is a blocking alarm and the pump cannot be controlled.
Green light: Pump ON/OFF signal.
if lit, the pump is running. If off, the pump is stopped.
plants), where a further reduction of the circu-
lator performance is ensured depending on the
lowering of the temperature of the circulating liq-
uid, when the demand for heating is lower.
floor heating plants), where the circulator perfor-
mance can be regulated only by activating the
temperature influence function.
10 MENUS
EVOPLUS circulators offer 2 menus: user menu and advanced menu.
The user menu is accessible from the Home Page by pressing and releasing the central
"Menu" button.
The user menu is accessible from the Home Page by holding down the central "Menu"
button for 5 seconds
Below are shown the user menu pages with which it is possible to check the system
status and modify its settings.
Instead on the advanced menu there are the configuration parameters for communica-
tion with MODBUS systems (for further details visit the link: http://www.dabpump.com/
evoplus). To leave the advanced menu you must scroll through all the parameters using
the central button.
If the menu pages show a key at bottom left it means that it is not possible to change the
settings. To unblock the menus go to the Home Page and press the hidden button and
the button under the key at the same time until the key disappears.
If no button is pressed for 60 minutes, the settings are automatically blocked and
the display switches off. When any button is pressed the display lights up again
and the "Home Page" appears.
To navigate in the menus, press the central button.
To return to the previous page, hold down the hidden button, then press and release the
central button.
To modify the settings use the left and right buttons.
To confirm the change of a setting, hold down the central button "OK" for 3 seconds.
Confirmation will be indicated by the following icon:
GB
ENGLISH
18