Assembling The Trimmer; Mounting The Deflector; Polycut 2-2 Mowing Head; Mounting The Trimmer Line - Stihl FSA 45 Manual De Instrucciones

English
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.

11 Assembling the Trimmer

11.1 Mounting the Deflector

WARNING
To reduce the risk of injury from thrown objects or contact
with the cutting attachment, never operate the trimmer
without a properly mounted deflector. Keep bystanders at
least 50 ft. (15 m) away.
To mount the deflector:
► Switch off the trimmer, @ 14.2.
► Remove the activation key, @ 13.2.
1
2
► Push the deflector (2) into the guides on the housing until
it stops.
The deflector must be tight against the housing.
► Insert and tighten the screws (3).
The line limiting blade (1) comes mounted in the deflector
and may not be removed.
20
3
2

11.2 PolyCut 2-2 Mowing Head

11.2.1 Mounting the Trimmer Line

WARNING
Use of metal cutting attachments, wire or metal-reinforced
line is not authorized and could be extremely dangerous.
Use only the cutting attachments recommended in this
manual, in combination with the recommended deflector,
@ 5.7.4.
WARNING
A damaged or loose cutting attachment or mowing head may
vibrate, crack, break or come off the trimmer, which may
result in serious or fatal injury or property damage. Make
sure the mowing head and cutting attachment are properly
tightened and in good condition before starting work,
@ 5.7.4.
To mount trimmer line on the PolyCut 2 - 2:
► Switch off the trimmer, @ 14.2.
► Remove the activation key, @ 13.2.
1
► From below, push the trimmer line up through the right
mounting hole and pull it back down through the left
mounting hole until it is even with the bottom of the arrow
(1).
► Hold the short end of the trimmer line firmly as you pull the
long end downward and then out through the notch in the
mowing head. Make sure the trimmer line is firmly seated
in the notch (2).
11 Assembling the Trimmer
2
0458-718-8621-A