SOMFY Passeo 500 Manual Del Usuario página 24

Using your PASSEO/AXOVIA
I Functionning in automatic mode
I n a u t o m a t i c f u n c t i o n i n g , p u s h i n g o n t h e re m o t e c o n t ro l b u t t o n p ro v o k e s
o p e n i n g o f t h e g a t e . I t s c l o s u re i s d o n e a u t o m a t i c a l l y a f t e r a t i m e d e l a y
p re v i o u s l y a d j u s t e d b y y o u .
It is possible to maintain the gate in the open position by giving a stop order (push again on
the remote control button) :
• at the end of opening, • at the beginning of closing.
or
STOP
STOP
I Going from auto mode to normal mode
STOP
In order to return to the sequential mode (the AUTO light is lit) :
• Place the remote control on the target engraved on the hood.
• Push on a button of the remote control until the AUTO light goes off.
> The normal mode (sequential functioning) is active.
PROG
AUTO
ON/OFF
:
STOP
STOP
PROG
AUTO
ON/OFF
Using your PASSEO/AXOVIA
J Securization of parametering
1 Push on the complete opening button
2
Push a second time on the button so that both leaves stop at mid opening
3
Cut off the mains supply 5 seconds
4
Turn back on the mains supply
5
Push on the complete opening button
The leaves MUST start up in the opening direction.
I Deleting emitters
1
• Push 1 second on the reset button.
> While pushing, the four lights turn
on.
STOP
2
• Release the reset button.
> The four lights go off for 2 seconds
> The ON/OFF light turns back on
> The PROG light turns on
All the recorded parameters are deleted : recorded
remote control, gate displacement, functioning
mode...
I Subsequent remote control addition
For a subsequent addition of remote controls, redo the following operations :
• Memorization of the remote controls.
• Memorization of gate leaf displacement.
Any new remote control memorization cancels and replaces the
preceding program of gate displacement
PROG
lights
AUTO
ON/OFF
reset
button
24