Troubleshooting Guide - Health Zenith SL-7001 Manual De Instrucciones

Ocultar thumbs Ver también para SL-7001:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

T
T
HINGS
• Periodically clean the solar panel with a soft cloth and
warm water. Do not hose spray. Keep the collector
clear of snow and leaves. Make sure trees and other
objects do not block sunlight from the panel.
• If not to be used for several weeks, turn the unit OFF.
Store it with the panel connected and where the panel
can gather sunlight.
• Solar collection is only effective in direct sunlight.
Every hour the light is on requires a minimum of 16
hours of sunlight charging. Solar panels collect less
than 10% of the sun's energy. Light bulbs convert this
energy to light at 5% efficiency.
• Several days of use with overcast skies may dis-
charge the battery. Because of the battery protection
circuit, the light will not work until the battery is fully
recharged.
• This light is supplied with a 15 watt bulb. Using a
larger bulb will decrease battery life.
SYMPTOM
POSSIBLE CAUSE
Lights will not
1. Battery is dead (Switch the sensor
come on.
OFF and let the battery charge for
three or more sunny days before
using again).
2. Sensor is turned OFF.
3. Lamp is loose or burned out.
4. Daylight turn-off is in effect (re-
check after dark) .
5. Incorrect aiming (Re-aim the sen-
sor to cover desired area).
Lights come on
1. Light Control may be installed in a
in daylight.
relatively dark location.
2. Light Control is in Test (Set control
switch to AUTO position).
Lights come on
1. Light Control may be sensing small
for no apparent
animals or automobile traffic (re-
reason.
aim sensor) .
2. Sensitivity is set too high (Reduce
sensitivity).
595-5291-04
R
:
O
EMEMBER

TROUBLESHOOTING GUIDE

SPECIFICATIONS
Range . . . . . . . . . . . . . Up to 50 ft. (15.2 m); [varies
Sensing Angle . . . . . . . Up to 100°
Lamp . . . . . . . . . . . . . . 15 watt, 6 volt halogen
Battery Type . . . . . . . . Sealed lead acid, 6 V 5.0 A-Hr.
On Time . . . . . . . . . . . 30 seconds, re-triggerable
Full Charge on Time . . Up to 1 hour
Replace lamp only with same type lamp, 20 watts or
less. DO NOT reverse the battery wires. Damage to
the unit will result. Like any lead-acid battery, this
battery must be disposed of properly.
DESA Specialty Products™ reserves the right to dis-
continue products and to change specifications at any
time without incurring any obligation to incorporate new
features in products previously sold.
SYMPTOM
POSSIBLE CAUSE
Lights stay on
1. Light Control is pointed toward a
continuously.
2. Light Control is in Test Mode
Lights flash on
1. Heat or light from the lamp may be
and off.
2. Heat being reflected from other
3. Light Control is in the Test mode
4. Battery is almost dead (Reduce
3
with surrounding temperature]
heat source like an air vent, dryer
vent, or brightly-colored heat-re-
flective surface (Reposition sensor) .
(Switch to Auto) .
turning the Light Control on and off
(Reposition the lamps away from
the sensor) .
objects may be affecting the sen-
sor (Reposition sensor) .
and warming up (Flashing is nor-
mal under these conditions) .
sensitivity. If flashing continues,
switch the sensor OFF and let the
battery charge for three or more
sunny days before using again) .
Tabla de contenido
loading

Tabla de contenido