Control Panel; Use & Operation - Honeywell MP10CESWW Manual Del Propietário

Control Panel

Power Control
Timer Control
Power Control
The Power Control turns the unit on and off.
Mode Control
3 settings: Cool, Dehumidify and Fan
A light will indicate which setting is being used.
• Cooling Mode
The unit works as an air conditioner. Adjust fan speed and air
temperature to suit your desired comfort level. Temperature
setting range is 61°F~89°F.
• Dehumidifying Mode
Air is dehumidified as it passes through the unit, without being in
full cooling mode. If room temperature is higher than 77°F
fan speed can be adjusted; otherwise fan speed is preset to LOW.
Note: If the unit will be used mainly as a dehumidifier, do not
connect the exhaust hose and let the warm air return in the
room. Continuous drainage is then necessary and more
efficient (see Continuous Draining).
• Fan Mode
For air circulation without air conditioner cooling.
Fan Speed Control
3 settings: High, Medium and Low.
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
Warning Light
Mode Control
USE & OPERATION
Timer / Temperature
Timer Light
Set Controls
Fan Speed Control
Temperature / Timer Set Controls
• Used for adjusting the timer and thermostat.
• The default display is room temperature.
• In cooling mode, when ▼ or ▲ button is pressed, the set
temperature is displayed and may be adjusted.
After 10 seconds the display will revert back to room temperature.
Temperature is only adjustable in cool mode.
The timer is adjustable between 1~24 hours.
Note: By pressing both ▼ / ▲ set buttons at the same
time, the display will toggle between Celsius and Fahrenheit.
Timer Control
While the unit is turned on, press the timer button then press the
▼ or ▲ to select the number of hours you would like the unit to
continue to run. The unit will turn off automatically.
Auto turn off:
While unit is running, press the press the ▼ or ▲ button to select
the number of hours you want the unit to run in air conditioning
mode.
Auto turn on:
When unit is in a standby mode (plugged in with power light on),
then press the ▼ or ▲ button to select the number of hours until
you want the unit to automatically start running.
Warning Light
Condensed water may accumulate in the unit. If the internal tank
becomes full, the Warning Light will illuminate and the unit will not
operate until the unit has been drained (see Water Condensation
Drainage).
10