Important Safety Instructions - EGO RTA2300 Traducción De Las Instrucciones Originales

Guaranteed sound power
level. Noise emission to the
XX
Noise environment according to
the European community's
Directive
This product is in
CE accordance with applicable
EC directives.
V Volt Voltage
No Load
n Rotational speed, at no load
Speed
0
min Per Minute Revolutions per minute
-1
Direct Type or a characteristic of
Current current
kg Kilogram Weight

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
◾
Avoid Dangerous Environments – Don't use
appliances on damp or wet slope.
◾
Keep guards in place and in working order.
◾
Keep hands and feet away from the cutting area.
◾
To reduce the risk of injury, never work on a ladder
or on any other insecure support. Never hold the
cutting unit above waist height.
◾
Check the cutting unit at regular short intervals
during operation, or immediately if there is a
noticeable change in cutting behavior.
◾
For best results, your battery should be charged in
a location where the temperature is greater than
5°C and less than 40°C. Do not store it outside or in
vehicles.
◾
If you are approached, stop the motor and cutting unit.
◾
Warn the operator of the danger of blade thrust.
◾
Blade thrust may occur when the spinning blade
contacts an object that it does not immediately cut.
◾
Blade thrust can be violent enough to cause the unit
and/or operator to be propelled in any direction, and
possibly lose control of the unit.
◾
Blade thrust can occur without warning if the blade
snags, stalls or binds.
◾
Blade thrust is more likely to occur in areas where it is
difficult to see the material being cut.
◾
Do not attach any blade to a unit without proper
installation of all required parts. Failure to use the
proper parts can cause the blade to fly off and
seriously injure the operator and/or bystanders.
Discard blades that are bent, warped, cracked,
broken, or damaged in any way. Use a sharp blade
A dull blade is more likely to snag and thrust.
◾
A coasting blade/line can cause injury while it
continues to spin after the motor is stopped or
trigger is released. Maintain proper control until
the blade/line has completely stopped rotating.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
even when the tool is not operating. Take care when
performing maintenance or service.
◾
Do not wash with a hose; avoid getting water in
motor and electrical connections.
◾
If situations occur that are not covered in this
manual, use care and good judgment. Contact the
EGO Customer Service Center for assistance.
◾
Use only with battery packs and chargers listed in fig. A2
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
No-load Speed
Cutting Blade
Recommended Operating
Temperature
Recommended Storage
Temperature
Weight
(without battery pack)
Measured sound power level L
WA
Sound pressure level at operator's
ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
ROTOCUT ATTACHMENT—RTA2300
EN
450±5%rpm
ABR2300
0°C-40°C
-20°C-70°C
2.6 kg
97.36 dB(A)
K= 2.7 dB(A)
83 dB(A)
K= 2.5 dB(A)
100 dB(A)
WA
5