Charging Instructions; Function Display - Juice BOOSTER 2 Manual De Instrucciones

Operating instructions
⚠ C A U T I O N
• Use your charging equipment exclusively at
power sockets and charging stations for which
you have original JUICE mains adapters. The
device charges your vehicle with single- or
three-phase AC voltage ranging from 6 to 32
ampere (A). Use only original JUICE accessories
equipped with the original JUICE CONNECTOR.
• Protect your charging equipment against
damage from being run over, dropped, yanked,
kinked or crushed.
• To prevent overheating while charging, do not
expose your JUICE BOOSTER 2 to direct sun-
light or other sources of heat for long periods
of time. If the JUICE BOOSTER 2 becomes
overheated, charging is automatically interrupt-
ed until the unit's temperature drops to within
its normal operating range.
• In many countries, industrial power outlets must
be equipped with a Type-A residual current de-
vice (RCD). JUICE recommends that a Type-A
RCD be installed in power sockets of any kind.
Please observe the regulations in force in the
country of use, as these always take prece-
dence. As the JUICE BOOSTER 2 is already
fitted with a built-in DC residual current monitor,
you don't have to bother with pricey installation
of a Type-B RCD or Type-A power supply.

Function display

Button for charging status/mode SELECT
Green LED
AMPERE: Displays the automatically set or indi-
vidually reduced amperage value (i. e. the charge
intensity).
Yellow LED
MODE: Indicates the preselected mode.
User Manual JUICE BOOSTER 2 [JTJB2-EU2R*] V 3.1
Red LED
FAULT: Displays the cause in case of a fault.
On the back of the device you'll find a How-To
quick-start guide, hazard warnings, the unit's serial
number and other product information.

Charging instructions

⚠ D A N G E R
• Always perform charging operations in the
specified order of steps.
• Always stop the charging process before you
remove the charger vehicle-end connector
from the vehicle charger socket.
• Never disconnect any plug (neither from the
power socket, nor on the JUICE CONNECTOR)
while the charging process is ongoing.
• Potential charging faults (FAULT) are identi-
fied on the device's function display. (Further
information in this regard can be found in the
section on Fault indications).
• Vehicles fitted with a Type-2 charging socket
lock the charge coupling during the charging
process, and the coupling remains locked as
long as the car is locked. This protects the
JUICE BOOSTER 2 against theft.
• Should any unauthorised party disconnect the
mains-end cable from the power socket during
the charging process, when the cable is recon-
nected to the socket the charging process will
automatically continue at the recently detected
or manually reduced charge current intensity.
Vehicle-end charging connection
Please consult the vehicle user manual for infor-
mation on plugging in the connector, locking and
unlocking the coupling, stopping the charging
process, unplugging the connector from the ve-
hicle-end socket, and the status of charging and
the connection at the vehicle.
Changing the mains-end adapter
⚠ D A N G E R
23