Alessi Plissé Manual De Instrucciones página 17

been reached the 2 marks present
on the motor unit and the adapter
will be line up. (fig. 4)
• Insert the hand blender into the
measuring jug or other container of
sufficient width and depth used to
hold the ingredients. (fig. 5)
• Do NOT insert the full length of
the shaft and especially do not
immerse the hand blender past the
point where the shaft connects to
the motor unit (fig. 5)
• The maximum capacity of the
measuring jug is 700 ml. To keep
ingredients from spilling out, do
not fill past 2/3 of maximum
capacity.
• Never fill the jug with hot
ingredients. Let the ingredients cool.
• Insert the plug into the power socket.
• Hold the container firmly with one
hand. (fig. 6)
• Press button 1 for slower mixing,
button 2 TURBO for faster mixing.
• Continue pressing on the button
throughout use, until you achieve
the desired consistency.
• For optimal blending, we
recommend holding the shaft at
a slight angle inside the container
and to move through the mix in a
circular manner (fig. 6)
• After mixing release the button.
• To avoid splattering, be sure the
blade has stopped moving before
removing the hand blender from
the preparation.
ATTENTION!
If you use the hand blender to
blend foods in a pan right after
cooking (e.g. for a vegetable
puree), be sure to take the pan
off the heat source first to avoid
overheating the mixer's detacha-
ble shaft. Be careful not to fill the
pan over 2/3 capacity to keep the
food from spilling over.
MDL10 Istruzioni versione 11-20.indd 17 MDL10 Istruzioni versione 11-20.indd 17
ATTENTION!
Remove the plug from the socket
immediately after you finish using
the appliance and before any clea-
ning or maintenance operation.
Always wait for the blade to stop
moving.
Unless the recipe specifies otherwise,
always start at speed 1, the lowest
setting, and then increase the speed as
necessary. Move the mixer clockwise
and from top to bottom keeping it at
a slight angle.
HOW TO CARE
FOR THE HAND BLENDER
After you finish mixing, wait for the
blade to stop spinning, remove the
plug from the socket and then remo-
ve the detachable shaft by turning
anticlockwise and pulling down. (fig. 7)
• Motor unit: Clean the motor unit
with a damp cloth ONLY.
• Detachable shaft: Wash the shaft
with warm water and washing-up
liquid. The shaft can be washed in
the dishwasher, but place it in the
top rack to avoid contact with the
heating elements. Dry carefully.
If you use particularly salty foods,
rinse the blade immediately after use.
If food items cling to the blade,
release the button, wait for the
blade to stop spinning and unplug
the mixer.
Use a tool – not your fingers – to
remove the pieces of food.
To avoid cuts, do NOT touch the
blades.
• Measuring jug: Wash by hand with
warm water and washing-up liquid.
17
ADVISE
26/11/20 11:20 26/11/20 11:20