Mounting The Radiator On The Wall; Electrical Connection - S&P EMIDRY-DP Manual Del Usuario

a bathroom, position the appliance in such a way that its controls cannot be
reached by persons using the bath or shower. (See fig. 5)

4. MOUNTING THE RADIATOR ON THE WALL

Once a suitable installation point has been selected, proceed as follows:
- Minimum distances, as indicated in Fig.1 must be respected.
- Once the radiator has been positioned it is necessary to mark its position
(E.g., with two pieces of adhesive tape), as indicated in Fig. 2. Remove the
radiator.
- Use the template included in the radiator box and mark the holes (Fig, 3).
- Insert the plugs and fit the upper brackets.
- Hang the device, make sure it is level and tighten the brackets.
- Position the lower bracket in one of the central grooves (Fig. 4).
- Mark, drill, insert the plugs and secure the lower bracket.

5. ELECTRICAL CONNECTION

IMPORTANT
In situations where the same EMIDRY heating installation comprises 2 or more
heaters interconnected as part of a home automation network, the power
cables of each appliance should be connected to the mains supply in the same
phase and in the correct order. Failure to do so may cause a short circuit:
Brown: Live
Blue: Neutral
Black: Home automation network (See Chapter 6)
EMIDRY appliances must be correctly wired if they are to function properly and
without problems. Wiring is perfectly simple, but certain conditions must be
respected. First of all, the mains supply must be compatible with the voltage
indicated on the appliance; it should be in compliance with all applicable
regulations and should have the necessary power rating for connecting all
appliances. This appliance is designed to be permanently connected to a fixed
installation. The heater's power circuit should incorporate an omnipolar circuit
breaker with at least 3 mm separating the contacts. Various appliances can be
protected by the same circuit breaker, on condition that the sum of the currents
of the appliances connected to each circuit breaker does not exceed the
latter's capacity. For the above purposes (and for purposes of necessary wire
sections) we indicate below the amperages corresponding to the power ratings:
500 W: 2,2 A
750 W: 3,3 A
1000W:4,3 A
1250 W: 5,4 A
1500 W: 6,5 A
15