Timer Function; Infrared Mode - S&P EMIDRY-DP Manual Del Usuario

seconds have elapsed and the keys have not been pressed again, the value is
accepted and the display returns to normal mode.

8.5 Timer function

With this function the appliance can be programmed to stop or to start from
anything between 15 minutes and 99 hours and 45 minutes in advance, in
increments of 15 minutes.
This means the appliance can be programmed to keep running for a certain
time e.g. after going to bed, or to restart e.g. before getting up - or even after
being off for e.g. a whole weekend.
To activate this function:
1 Press and hold
the Timer function is activated, in which case the time remaining (countdown) is
displayed.
2 Press and
After 5 seconds the setting is accepted, the display once again shows the
ambient temperature and the clock begins its countdown.
3 Once the countdown has expired the appliance acts as follows:
1-. If it is in standby, it enters
2-. If it is in ,
8.6 Simplified operation
Press and hold the
the first option, starting from standby, is
simplified manner as follows:
Press and hold
Press and release

9. INFRARED MODE

The appliance features an infrared receiver allowing it to be controlled via a
remote control unit (optional). Programming and transmission instructions are
explained in the instructions for the remote control unit .
The "MP-EMIDRY" heater by S&P includes an optional remote control unit.
With just one remote control you can easily program and control all the
appliances in your heating installation.
The MP-EMIDRY remote control unit features:
for 5 seconds. On the display "00" flashes, except when
to select the desired timer setting (increments of 15 minutes).
mode.
or , or mode the appliance shuts down.
button for 2 seconds to switch the appliance off. Since
: STOP
:
, the appliance can be used in a
19