Setup Menu - Grundfos LC 221 Manual De Instrucciones

7.2 Setup menu

All settings are preset except for the start level. The start level
depends on the inlet height and must be set during the startup
phase. See section 5.4 Connecting the level sensor. However, in
case adjustments are required, settings can be made via the
setup menu. To open the setup menu, mark the symbol
the button [>] and press [OK]. Navigate through the menu by
means of the buttons [>] and [<]. Select the desired menu item by
pressing [OK]. Enter values or select settings from a list by
means of the buttons [>] and [<]. Save the settings by pressing
[OK]. See also fig. 9.
Setup menu
Fig. 9 Menu structure for setup menu
using
L_01 Start level [mm]
I_02 Rated current [A]
T_01 Stop delay [sec.]
T_02 Start delay [sec.]
T_03 Alarm delay [sec.]
S_01 Sensor selection
C_01 Calibration
C_02 Offset
M_01 Maintenance interval [month]
A_01 Reset alarm
G_01 Reset to factory settings
EXIT Back to main menu
The following settings can be made:
• start level
• rated current
• stop delay
• start delay
• alarm delay
• sensor selection
• sensor calibration
• sensor offset
• time for maintenance
• alarm reset (manually or automatically)
• reset to factory settings.
180
250
315
(416)
3.8
2
0
5
S00, S01
490 (MD)
715 (MLD)
0, 3, 6, 12
Manual/
Automatic
EXIT
*)
15