Setup - Grundfos Conex DIA-2Q Manual De Instrucciones

11.5 Setup

All standard settings of the device can be defined in
the "setup" menu. During initial commissioning, basic
functions are configured which after that should only
be altered rarely or even not at all.
The "setup" menu can only be accessed by persons
having full rights.
See section 11.5.8 Code
Enter the code number.
11.5.1 Selection of measured values for chlorine, chlorine dioxide, ozone, peroxide, peracetic acid, pH,
redox
setup
parameter 1
off
chlorine
chlorine dioxide
ozone
parameter 2
off
pH
redox
Fig. 26 Selection of measured value in menus "parameter 1" and "parameter 2"
* pH-comp. chlorine is only available if chlorine and
pH have been selected as parameters.
1. Select the line "parameter 1"/"parameter 2" using
the [Up] and [Down] buttons, and press [OK] to
switch to the corresponding menu.
2. Use the [Up] and [Down] buttons to select the
measured variable (parameter). Press [OK] to
confirm.
3. Use the [Up] and [Down] buttons to select further
settings. Press [OK] to confirm.
30
function.
temp. meas.
on
off
temp. meas.
on
off
temp. comp.
on
off
pH-comp. chlorine*
on
off
temp. meas.
on
off