Spare Parts - Ghibli M26 Uso Y Mantenimiento

- Dispense the liquid from the nozzle until
clean water comes out.
- Empty the water in the detergent tank as
described above.
Cleaning the appliance body
- Clean the unit body with a cloth damp-
ened with water or a mild detergent.
- Remove the cover as indicated previous-
ly and clean the inside of the tank with
running water, leaving the drain hose
open (28 Fig.23) then reassemble every-
thing proceeding in reverse order.
DANGER:
Do not wash the appliance using jets of
water.
Periodic checks
Cleaning the detergent dispensing
nozzle
If you note that the detergent is not dispensed
evenly, clean the nozzle as described below:
- Remove the ring nut (34 Fig.24).
- Remove the nozzle (35 Fig.24) and clean
it with running water, if it is clogged use a
pin being careful not to distort the shape
of the nozzle.
- Reassemble all of the parts performing
these operations in the reverse order.
Cleaning the detergent suction filter
If you note that the detergent is not being
suctioned properly, check and clean the suc-
tion filter located inside the detergent tank.
- Using a screw driver, loosen the suction
cap (36 Fig.25) and remove it from the
tank with the relative suction hose.
- Remove the filter (37 Fig.25) and wash it
under running water; if it is too clogged it
should be replaced.
- Reassemble all of the parts performing
these operations in the reverse order.
Replacing the floor nozzle squeegee
(if present)
If when washing the floors the washing liquid
is not suctioned properly and the floor or car-
pet remains wet, check the condition of the
squeegee (38 Fig.26).
If the blade is worn or damaged should be
replaced by releasing the blade support (39
Fig 26) from the nozzle.
When replacing the new blade pay attention
to insert it properly into the mouthpiece, then
press until you hear the click coupling (Fig.
27).

SPARE PARTS

Slide nozzle body ................. Code 7217519
EN - 9
EN