Ghibli M26 Uso Y Mantenimiento página 15

Professional hose assembly for fabric
washing (if present)
After connecting the suction hose to the out-
let the drum, do as follows:
- Insert the fabric nozzle (18 Fig.12) into
the flexible hose (15 Fig.12).
- Connect the detergent hose (19 Fig.12)
to the quick coupling (16 Fig.12) on the
flexible hose; to release it push the quick
coupling (16 Fig.12) towards the hose.
Filling the detergent tank.
- Remove the cap (20 Fig.13) and pour the
detergent liquid (suitable for the surfaces
to be washed) into the tank (7 Fig.13).
NOTE:
For detergent dosing refer to the manufac-
turer's instructions.
- Put the cap back on (20 Fig.13)
USING THE APPLICANCE
- The appliance is fitted with wheels and
can therefore be pulled along using the
flexible hose, or pushed with the handle
(21 Fig.14)
- For lifting, two people, put your fingers in
its handles (22 Fig.14).
Starting up the appliance
- Insert the plug (23 Fig.15) into the electri-
cal socket.
- Press the switch (24 Fig.16) to "I" to start
the engine intake.
- Push the switch (25 Fig.16) on "I" to start
the detergent pump; the switch lights up.
NOTE:
The suction motor and the detergent pump
operate independently; therefore, it is pos-
sible to:
- wash fabrics or floors/ carpets by starting
only the detergent pump;
- wash and suction liquid simultaneously
by starting up the detergent pump and
suction motor at the same time;
- suction liquids by only starting the suction
motor.
Washing floors or carpets
- For washing floors or carpeting is neces-
sary to fit the rigid tube (8-9 Fig. 17) and
the mouth floor (10 Fig.17), if present.
- Put the nozzle (10 Fig 17) perpendicular
to the floor / carpet (see Figure 17).
- Start the suction motor and the detergent
pump by pressing the relative switches
(24 - 25 Fig.16).
- Press the lever (26 Fig.17) to deliver the
cleaner, release to stop dispensing.
- The detergent released washes the floor/
carpet / and the dirty liquid is suctioned
into the tank of the appliance.
For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs.
EN - 7
EN