Cleaning And Maintenance; Daily Cleaning - Ghibli M26 Uso Y Mantenimiento

EN IT
Cleaning chairs
- Start the suction motor and the detergent
pump by pressing the relative switches
(24 - 25 Fig.16).
- Place the mouthpiece on the fabric and
press lightly ; than press the lever (27
Fig.18) to deliver the cleaner, release to
stop dispensing.
- For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs
Switching off the appliance
- Press the switches (24 and 25 Fig.13) to
"0" to switch off the appliance; the lamps
on the switches will go out.
- Remove the plug (23 Fig.12) from the
electrical socket.
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance op-
erations, unplug the appliance from the
electrical socket.

Daily cleaning

Emptying the recovery tank
- Position yourself over a floor drain with
the appliance.
- Detach the drain hose (28 Fig. 19) from
its relative support.
- Unscrew the knob (29 Fig. 19) and re-
move the cap (30 Fig. 19) of the water
drain hose (28 Fig. 19) and empty the liq-
uid into the recovery tank (31 Fig.19)
Cleaning the detergent dosing circuit
At the end of each workday, clean the de-
tergent dosing circuit as follows to prevent
clogging:
- Release pressure from the circuit by
pressing, with dosing pump off, the lever
(27 Fig 18) or lever (26 Fig 17)
- Disconnect the detergent delivery hose
(4 Fig.3).
- Lift up the levers (32 Fig.20) and remove
the cover (33 Fig.21) complete with mo-
tor.
- Remove the cap (20 Fig.13) of the deter-
gent container and tilt the tank (7 Fig. 22)
up to fully discharge the detergent in a
container.
- Wash the inside of the detergent contain-
er with running water.
- Reassemble all of the parts performing
these operations in the reverse order.
- Pour clean water into the detergent con-
tainer, electrically connect the appliance
and start the dosing pump by pressing
the switch (25 Fig.16).
- Clean the circuit by pressing the lever (27
Fig.18) or (26 Fig 17), depending on the
type of mouthpiece.
EN - 8