Cleaning And Maintenance; Daily Cleaning - Ghibli Wirbel M7 CE11/1 I Uso Y Mantenimiento

EN IT
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs.
Cleaning chairs
- Mount the fabric nozzle (30 Fig.16) on the
relative hose (31 Fig.16).
- Start the suction motor and the detergent
pump by pressing the relative switches
(24 - 25 Fig.13).
- Place the nozzle on the fabric pressing
slightly then press the switch (28 Fig.15)
or the lever (32 Fig.15), depending on the
nozzle type, to dispense the detergent,
release to stop dispensing.
For very dirty areas it is recommended
you apply detergent to the dirty area wi-
thout suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs.
All manuals and user guides at all-guides.com
Switching off the appliance
-
-
-
Before performing any maintenance op-
erations, unplug the appliance from the
electrical socket.

Daily cleaning

Emptying the recovery tank
-
-
-
-
-
-
Cleaning the detergent dosing circuit
At the end of each workday, clean the de-
tergent dosing circuit as follows to prevent
clogging:
-
-
-
EN - 8
Press the switches (24 and 25 Fig.13) to
"0" to switch off the appliance; the lamps
on the switches will go out.
Remove the plug (23 Fig.12) from the
electrical socket.
Wind up the cable (33 Fig.17) and hook it
onto its housing (34 Fig.17).
CLEANING AND
MAINTENANCE
DANGER:
Disconnect the detergent delivery hose
(4 Fig.3) and the flexible hose (1 Fig.2).
Disconnect the detergent suction hose (6
Fig.4).
Lift up the levers (35 Fig.18) and remove
the cover (36 Fig. 19) complete with mo-
tor.
Remove the detergent container (21
Fig.20) lifting it by the handles.
Place yourself over a floor drain and
empty the liquid in the recovery tank (37
Fig.21)
Clean the inside of the tank with running
water and then reassemble everything
proceeding in the reverse order.
Disconnect the detergent delivery hose
(4 Fig.3).
Disconnect the detergent suction hose (6
Fig.4).
Lift up the levers (35 Fig.18) and remove
the cover (36 Fig. 19) complete with mo-
tor.