Installation; Installing The Appliance - AEG MCD2660E Instrucciones De Manjo

1. AG-71+72D-EU English

Installation

INSTALLING THE APPLIANCE

1. Remove all packaging and check carefully for any
signs of damage.
2. If fitting the microwave oven above a conventional
oven (position A) then use the mylar sheet provided.
a. Cut the Mylar sheet to fit the internal width of
the unit.
b. Peel back the protective cover on the tape and fix
to the rear of the shelf
so that it covers
the service
gap. (See
diagram).
The microwave can be fitted in position A or B:
Position A
Conventional
oven
POSITION NICHE SIZE
W D
A 560 x 550 x 450
560 x 550 x 380
B 560 x 500 x 450
560 x 500 x 380
Measurements in (mm)
NOTE: Ensure the bottom of the oven is 85 cm or more above the floor.
40 40
17/11/2005 13:10
Mylar sheet
Conventional
oven
Chimney
Position B
CHIMNEY Gap Between
H (min) Cupboard & Ceiling
50
50
40
40
Page 40
3. Fit the appliance into the kitchen cupboard slowly,
and without force, until the front frame of the oven
seals against the front opening of the cupboard.
4. Ensure the appliance is
stable and not leaning.
Ensure that a 5mm gap is
kept between the cupboard
door above and the top of
the frame (see diagram).
5. Fix the oven in position with the
screws provided.
The fixing points are located on
the top and bottom corners of
the oven (see diagram, item 10,
on page 5).
6. It is important to ensure that the installation of this
product conforms to the instructions in this
operation manual and the conventional oven
manufacturer's installation instructions.
Chimney
50
50
50
50
5 mm