Optional Accessories - Virutex AG98R Manual De Instrucciones

TRIBUTION OF THE SURPLUS as explained in sections 4.
and 5. of this manual, for edges on a roll.
- Attach extension P1 (Fig. 10) level with the edge of
the board to be edgebanded and fix in place using
knob E1 (Fig. 10).
1 – Position the machine at the beginning of the board, so
that the vise clamps are equidistant from limit T1 (Fig. 11).
2 – Pull the pre-cut strip upwards (Fig. 11), until retainer
R1 (Fig. 11 y 12) hits the end of extension P1 (Fig. 12).
3 - Set the switch to position I or II to start the heater
and wait a few seconds until it reaches the correct
temperature and the glue in the edge starts to melt.
4 – Press the pre-cut strip firmly onto extension P1
(Fig. 12), pressing on knob M (Fig. 12), and move the
machine slowly along the board until you have finished
edgebanding.
Guide X (Fig. 8) has a non-stick coating
which prevents the glue on the strip from
sticking to guide X when it is hot.
To clean guide X (Fig. 8), use only sui-
table solvents.
Do not scrape off glue residues as this
would damage the coating.
9. MAINTENANCE
Before performing any maintenance operation, discon-
nect machine from power source.
Changing blades:
Remove screw N, (Fig. 4), which secures the blade block
to the gluing roller. Turn the machine over and loosen
the three screws P, (Fig. 6), that hold it to the fixed side.
Separate the blade block from the machine; (Fig. 13).
Remove strip guide Q, (Fig. 13), deflector R and rear
blade S, (Fig. 14).
The heads of screws T, (Fig. 13) securing the front blade
can be seen at the top of the blade block. Loosen and
remove these screws, releasing the front blade.
Change the blades and re-assemble the blade block
in the opposite order to that given for dismantling it.

10. OPTIONAL ACCESSORIES

5246025- Inclined roller (4°), for edging inclined
doors, etc.
11. NOISE AND VIBRATION LEVEL
The noise and vibration levels of this device have been
measured in accordance with European standard EN
60745-1 and serve as a basis for comparison with other
machines with similar applications.
The indicated vibration level has been determined for
the device's main applications and may be used as an
initial value for evaluating the risk presented by expo-
sure to vibrations. However, vibrations may reach levels
that are quite different from the declared value under
other application conditions, with other tools or with
insufficient maintenance of the electrical device or its
accessories, reaching a much higher value as a result
of the work cycle or the manner in which the electrical
device is used.
Therefore, it is necessary to establish safety measures
to protect the user from the effects of vibrations, such
as maintaining both the device and its tools in perfect
condition and organising the duration of work cycles
(such as operating times when the machine is subjected
to loads, and operating times when working with no-load,
in effect, not in use, as reducing the latter may have a
considerable effect upon the overall exposure value).
12. WARRANTY
All VIRUTEX power tools are guaranteed for 12 months
from the date of purchase, excluding any damage which
is a result of incorrect use or fo natural wear and tear
on the machine. All repairs should be carried out by the
official VIRUTEX technical assistance service.
13. RECYCLING ELECTRICAL EQUIPMENT
Never dispose of electrical equipment with domestic was-
te. Recycle equipment, accessories and packaging in ways
that minimise any adverse effect on the environment.
Comply with the current regulations in your country.
Applicable in the European Union and in European
countries with selective waste collection systems:
If this symbol appears on the product or in the accom-
panying information, at the end of the product's useful
life it must not be disposed of with other domestic waste.
In accordance with European Directive 2002/96/EC, users
may contact the establishment where they purchased the
product or the relevant local authority to find out where
and how they can take the product for environmentally
friendly and safe recycling.
VIRUTEX reserves the right to modify its products wi-
thout prior notice.
9