Front Panel
System Status LEDs
This section describes the following elements on the front panel of an SSG 20
device:
System Status LEDs
Port Descriptions
Mini Physical Interface Module Port Descriptions
The system status LEDs display information about critical device functions. Figure 3
illustrates the position of each status LED on the front of the SSG 20-WLAN device.
The WLAN LEDs are only present on the SSG 20-WLAN device.
Figure 3: Status LEDs
POWER
STATUS
When the system powers up, the POWER LED changes from off to blinking green,
and the STATUS LED changes in the following sequence: red, green, blinking green.
Startup takes approximately two minutes to complete. If you want to turn the
system off and on again, we recommend you wait a few seconds between shutting
it down and powering it back up. Table 2 provides the name, color, status, and
description of each system status LED.
Table 2: Status LED Descriptions
Name
Color
POWER
Green
Red
STATUS
Green
Red
PIM 1
Green
1
2
802. 11a
PI M 1
PI M 2
b/g
WLAN
Status
Description
On steadily
Indicates that the system is receiving power.
Off
Indicates that the system is not receiving
power.
On steadily
Indicates that the device is not operating
normally.
Off
Indicates that the device is operating
normally.
On steadily
Indicates that the system is starting or
performing diagnostics.
Blinking
Indicates that the device is operating
normally.
Blinking
Indicates that there is an error detected.
On steadily
Indicates that the mini PIM is functioning.
Blinking
Indicates that the mini PIM is passing traffic.
Off
Indicates that the mini PIM is not
operational.
Front Panel
11