Idiomas disponibles
Idiomas disponibles
for Venturi effect the suction of the aquarium water from the grid FIG.6 N ° 7 with return to the aquarium through the water outlet cock FIG .6 N ° 9. Warning: never
let the ballast work with the water outlet tap FIG.6 N ° 9 completely closed.
ADJUSTMENT: once the Calcium reactor has been installed and started up, check that the pump is working correctly and that the aquarium
water is sucked in from the grill FIG.6 N ° 7 with return to the aquarium through the water outlet cock FIG.6 N ° 9 the appliance can be adjusted:
- slowly close the water outlet cock FIG.6 N ° 9 until a flow of 1 to 3 l / h is obtained;
- slowly open the valve of the CO2 pressure reducer and dispense CO2 with a flow rate indicative of 1 bubble per second (verifiable through the bubble counter FIG.6
N ° 4);
- in case of use with pH-meter the CO2 flow must be regulated between 1 and 2 bubbles per second and the
controller must be set so that the solenoid valve closes the CO2 supply when the pH falls below the value of 6.70;
-after 24h (or in accordance with the instructions given by the manufacturer of the material inserted
in the reactor) check the alkalinity of the water leaving the reactor which should be higher than that
of the aquarium. We recommend the reactor so that the KH of the outgoing water is 25-30 ° dKH;
- to increase or decrease the alkalinity of the outgoing water it is necessary to increase the CO2 supplied
(increase in KH water at the outlet) or decrease the CO2 supplied (decrease in KH water at the outlet);
- in case of use with pH-meter the regulation will be done by acting on the limit value of the pH (decreasing the limit value of the
pH will increase the KH of the outgoing water and increasing the limit value of the pH will decrease the KH of the outgoing water) ;
- after a week check the KH value in the aquarium water to check the operation of the appliance. If the KH value is still low, the water flow exiting
from the water outlet tap FIG.6 N ° 9 should be increased, vice versa if it is too high the flow should be reduced. If you go to change the outflow
water after 24h the KH value of the outgoing water must be re-checked and set back to between 25 and 30 ° dKH according to what was seen above;
- check the value of the KH of the aquarium water weekly and, if necessary, repeat the correction operations described above."
In case of excessive saturation of CO2 in the reactor (presence of many bubbles that do not dissolve) or in case of precipitation of the pH in the reactor (internal water
that turns white) intervene by reducing the emission of CO2 into the reactor. Both of these situations can cause problems for the reactor or risks for the aquarium.
"Maintenance: we recommend checking the calcium reactor daily to check its operation, sealing and outgoing CO2 and water flows. Weekly measure the flow and
KH of the water leaving the reactor and, if necessary, correct them.
Every 90-120 days, a complete cleaning and check-up of the calcium reactor must be carried out. To do this, disconnect the calcium reactor pump from the electric
socket as well as all the other electrical appliances in the water, remove the calcium reactor from the sump tank, remove it completely and clean it under running
tap water. Be careful at this stage not to wet or immerse the pump plug in water. Also remove and clean the impeller from the pump. If the impeller is particularly
encrusted, we recommend soaking it for a few minutes in water and vinegar (diluted 10%), taking care to rinse it thoroughly under running tap water to remove all
traces of vinegar. Completely replace the material inside the reactor. Reassemble everything in reverse order and according to the instructions given above, restart
the reactor and adjust it again.
In the event of a significant increase in noise or vibrations produced by the calcium reactor, it is advisable to inspect and clean both the water inlet and outlet pipes
to eliminate any obstacles, and the impeller.
Do not use chemicals or products not specifically marketed to clean the calcium reactor.
WARRANTY: This product is guaranteed for a period of 24 months, from date of purchase, against defects in materials or workmanship. The guarantee certificate
must be completed in its entirety by the dealer and must accompany the product in the event that it is returned for repair. The warranty consists in the replacement
of defective parts. This warranty does not apply in case of improper use, nor liable for damage caused by tampering or negligence by the purchaser. For warranty
service, return the device together with the purchase receipt or equivalent, with a detailed description of the problem. Excluded from warranty are all parts subject
to wear and tear.
• The manufacturing company assumes the commitment to replace at its discretion the malfunctioning or incorrect manufacturing parts, only after careful quality
control and detection of poor construction.
• Always charged to the buyer are the cost of transport and / or delivery in case of misuse of warranty terms
• During the warranty period, replaced products become property of the manufacturer.
• Of this guarantee can only benefit the original purchaser who has complied with the normal maintenance instructions in the manual. Our liability on the guarantee
expires when: the original owner sells the product properties, or when changes were made to the same.
• The product that is part of the defective product must be delivered to the manufacturing company for replacement; otherwise, the replaced part will be charged
to the purchaser. FAILURE TO OBSERVE THE MODES OF INTERVENTION AND THE USE OF LIGHTING EQUIPMENT FOR AQUARIUMS DESCRIBED IN THIS DOCUMENTATION
(INSTRUCTION AND MAINTENANCE MANUAL AND ATTACHED MANUALS) ENTAILS THE DECAY OF THE WARRANTY TERMS. If even small parts break, replace the product.
If parts of the product are swallowed, contact your vet.
RECYCLING:The appliance is marked with the appropriate symbol which indicates that the product must not be disposed of with other household waste at the end of
its life cycle, but through separate separate collection of electrical and electronic equipment. To avoid damage to the environment or to health caused by inadequate
waste disposal, the purchaser is invited to separate this appliance from other types of waste and recycle it responsibly to facilitate the re-use of material resources.
Domestic users will be able to return the appliance to the retailer when buying a new one-to-one equivalent appliance, or contact the local office in charge for all
the information regarding recycling and recycling for this type of product.
Business users must not dispose of this appliance together with commercial waste, but through a separate collection system compatible with the European directive
2002/96 / EC.
Disposal that does not comply with current regulations is punished with administrative penalties as per current legislation.
