Specifications; Bolt Size / Torque Specs; Frame Specifications; Recommended Tire Pressures - Specialized Bicycle Components VADO Serie Traducción De Las Instrucciones Originales

WARNING! Correct tightening force on fasteners (nuts, bolts, screws) on your bicycle is important
for your safety. If too little force is applied, the fastener may not hold securely. If too much force is
applied, the fastener can strip threads, stretch, deform or break. Either way, incorrect tightening
force can result in component failure, which can cause you to lose control and fall.
Where indicated, ensure that each bolt is torqued to specification. After your first ride, and
consistently thereafter, recheck the tightness of each bolt to ensure secure attachment of the
components. The following is a summary of torque specifications in this guide:
LOCATION
SEAT COLLAR
SEATPOST @ SADDLE
STEM @ STEERER TUBE
STEM @ HANDLEBAR
DERAILLEUR HANGER
REAR AXLE
REMOTE
CAUTION: Ensure all contact surfaces are clean and bolt threads are greased or have a
threadlocking compound (refer to the instructions for each bolt) prior to installation.
ITEM
HEADSET
SEAT COLLAR DIAMETER
SEATPOST DIAMETER
DERAILLEUR HANGER
REAR HUB
FRONT HUB
WARNING! VADO/COMO frames are compatible only with VADO/COMO rigid forks or suspension
forks with 50mm maximum fork travel. Use of different forks negatively affect geometry and ride
quality, and, most importantly, may result in catastrophic failure of the frame which may result in
serious personal injury or death.
Proper tire pressure is critical for optimal performance. Tires with higher pressure will typically roll faster and provide
less rolling resistance, but provide less traction. Tires with lower pressure will typically provide increased traction
and control at the expense of rolling resistance.
Use a quality pressure gauge and refer to the tire pressure recommendations written on the side of the tires.
Because of the extra weight of the VADO/COMO, as a rule of thumb, tire pressure should generally
be higher compared to a regular bicycle.
23

11. SPECIFICATIONS

11.1. BOLT SIZE / TORQUE SPECS

IN-LBF Nm
45 5.1
120 13.5
52 6.0
52 6.0
35 4
133 15
7 0.8

11.2. FRAME SPECIFICATIONS

11.3. RECOMMENDED TIRE PRESSURES

LOCATION
FRONT AXLE
CRANK BOLTS
CHAINRING BOLTS
SPIDER LOCKRING
REAR BRAKE GUIDES
WATER BOTTLE BOLTS
MOTOR COVER SCREWS
SPECIFICATION
1 1/8" UPPER / LOWER
34.9MM
30.9MM
S172600003 (AMAZINGER 2.1)
148MM X 12MM
100MM X 15MM
IN-LBF Nm
133 15
443 50
89 10
443 50
6 0.7
25 2.8
7 0.8