Power & Status - Sanyo POA-WL11 Operación Manual

Chapter 5. Operating the WI Client
3. After the initial settings are completed, select other menu items in Main Menu to operate or configure
the projector.
Refer to [5.4.1. Power and Status] ~ [5.4.3. Display Menu] for more detailed descriptions of each
menu item.
[NOTE] The menu items may vary depending on the projector type.
4. When you finish controlling or configuration using PJ Controller, select [Exit] from [File] menu and exit
PJ Controller application.
[NOTE] You cannot connect to Wireless Imager in either Real-Time mode or in One-Shot mode
while PJ Controller is running.
5.4.1. Power & Status
In Power & Status screen, you can configure
and control projector's power.
Parameter
Projector Power
Accumulated Lamp-use time
Accumulated Projector-use
time
Power Status
Projector Condition
Input Status
[NOTE] Since configuration parameters vary depending on the projector model, the contents
mentioned above may be different from the actual configuration. For details, refer to
Owner's Manual of each projector.
You can control projector's power by clicking either [Standby] or [ON]
button.
[NOTE] You cannot turn on the projector for approximately 90
seconds after shutting down the power. If the projector's
LED is indicating [Cooling] status, you cannot turn on the
projector. Wait until the indicator light turns from [On cooling
down] to [Standby], then click [ON] button to turn on the
power.
Accumulated time of lamp use is displayed in an hour increment.
This counter is reset when the lamp is replaced and by resetting the
Lamp replacement counter.
Accumulated projector use time is displayed in an hour increment.
The status of projector's lamp is displayed in following status:
ON, Standby, Lamp Off/Standby, OFF, On cooling down, Lamp
Off/On cooling down, Power Saver Mode/On cooling down,
Temperature Error/On cooling down, On starting up, On power
management operating, Temperature Error/Standby
The projector's condition is displayed in following status:
Normal, Temperature Error, Power Failure, Lamp Off, Standby
Selected mode and the signal status are displayed.
— 56 —
Description