Pj Controller - Sanyo POA-WL11 Operación Manual

5.4. PJ Controller

With PJ Controller, you can operate and configure the projector to which Wireless Imager is installed.
1. Right-click the icon in the system tray, and make sure that WI Client is in [Disconnected] state.
Verify also that the correct target is selected.
[NOTE] You cannot launch [PJ Controller...] while the PC is connected to Wireless Imager in either
Real-Time mode or in One-Shot mode. Make sure that WI Client is in [Disconnect] state.
Right-click the icon in
the system tray
2. Select [PJ Controller...] from the menu and launch PJ Controller.
Next, select [Initial Setting] from Main Menu, and configure appropriate fields.
Make sure that you select correct [Model Name].
Parameter
Language
Model Name
Comment
Select a desired language from the pull-down menu, and click [Set] button.
Select a model name of the projector to which Wireless Imager is installed.
Model Name is listed as code in OPTIONAL PARTS section of the projector's
owner's manual.
[NOTE] If you do not select correct model name, you will not be able to operate
or configure the projector using PJ Controller.
You can store any comments regarding the initial settings. To save the
comments you entered, click [Save] button.
— 55 —
Chapter 5. Operating the WI Client
About Model Name:
Model Name is the actual model name of the
projector you wish to control with PJ Controller.
Model Name is shown as code in OPTIONAL
PARTS section in your projector's owner's
manual. Check your projector's model name
carefully and select the correct Model Name
code from pull-down list. In order to control
your projector properly, you must select the
correct Model Name Code.
Description