Sanyo POA-WL11 Operación Manual página 36

Chapter 4. Setting up Wireless Imager
Parameter
ARP+PING
If the contents you have set on this page are correct, click the [APPLY] button.
The screen prompting you to restart Wireless Imager will appear. If no other configuration change is
necessary, click the [RESTART] button to restart Wireless Imager. The changed settings will take effect
upon Restart.
[NOTE] To return the contents you have set to the previous settings, click the [REFRESH] button
before pressing [APPLY] button.
To return the settings to the factory default settings, click the [Restore Factory Default
Settings] button. Only TCP/IP setup items are then returned to the factory default
settings.
Whether the IP address setup with "arp" and "ping" commands is made
enabled or disabled is selected.
Normally, the default setting "Enable" can be used.
For details about how to set the IP address with ARP+PING, see [6.2.
Setting the IP address with "arp + ping" command] in Chapter 6.
— 36 —
Description