Sanyo POA-WL11 Operación Manual página 29

9. Next, the TCP/IP setup screen will appear. Set the following items and click the [Setup] button.
After that, the screen prompting you to confirm the changes will appear. Click [OK] button.
In this manual, TCP / IP is set up as follows:
(This figure is different from the actual settings.)
• Enable DHCP:
• IP address:
• Subnet mask:
• Gateway address:
[NOTE] Set values in [IP Address] and [Subnet Mask] so that the communication can be
performed with the personal computer you are using. If any segment beyond the
router is not used, the gateway address can be left at "255.255.255.255". For details
about these settings, consult with your network administrator.
If the admin password is already set, it is required to input the password when clicking
the [Setup] button. For details about admin password, see [4.3.5. Advanced setup -
Admin Password] in Chapter 4.
If you change the settings of Wireless Imager by the browser or WI set while it is
transmitting data in Real-Time Capture mode, the settings prior to the change may be
shown on the display when you view the settings values from the projector's menu.
At this point, the changed settings are already in effect.
[Disconnect] from Real-Time Capture mode, and view the settings from the
projector's menu again. Then the new settings will be displayed.
10. Click "Finish" button. When the "TCP/IP Configurations" screen of the IP address setup tool
(WI Set) appears, click [No] to exit WI Set.
Chapter 4.
Disable (Uncheck the check box)
169.254.1.100
255.255.255.0
169.254.1.1
— 29 —
Setting up Wireless Imager