Setting The Ip Address With Wi Set - Sanyo POA-WL11 Operación Manual

4.2. Setting the IP address with WI Set

To set the IP address of Wireless Imager, you can use WI Set included in the software CD-ROM.
[NOTE] WI Set cannot be used to set Wireless Imager through the router or gateway. Always
use the personal computer in the same segment as that of Wireless Imager. (Only
when the wireless mode is Infrastructure)
1. Check the MAC address (12-digit alphanumeric characters) on the label attached to the back of
Wireless Imager.
[CAUTION] Before removing Wireless Imager, be sure to disconnect the projector's power
[NOTE] MAC address is a unique hardware address assigned to each Wireless Imager,
displayed on a label attached to the back of the unit.
2. Mount Wireless Imager to the projector and connect the power cord of the projector to AC
outlet. If the main switch (MAINS SW) is provided to the projector, make the switch ON.
(Not necessary to make the projector projecting.)
3. Insert Software CD-ROM into the personal computer's CD-ROM drive.
4. CD-ROM will start automatically and display Language Selection window. Select the language
from the pull-down menu and press OK button.
[NOTE] If the "Language Selection" screen does not appear automatically, open [CD-ROM
drive] of [My Computer] of the personal computer and run "AutoRun.exe". The
"Language Selection" screen will appear.
5. "Software License" window will be displayed.
Thoroughly read the contents. If you agree to the contents of the software license agreement,
check on the [Agree] radio button and click [OK].
plug from AC outlet.
— 27 —
Chapter 4. Setting up Wireless Imager